Dynamic Cleat Test with Perpendicular and Inclined Cleats
This SAE Recommended Practice describes a test method for measuring the forces and moments generated at a high frequency response spindle when a rolling tire impacts a cleat. The cleat is configured either with its crest perpendicular, 90 degrees, to the path of the tire or optionally with its crest inclined at an angle to the path of the tire. The carriage to which the spindle is attached is rigidly constrained in position during each test condition to provide a good approximation to fixed loaded radius operation. The method discussed in this document provides impact force and moment time histories essentially free from variations due to tire non-uniformities. The method applies to any size tire so long as the equipment is properly scaled to conduct the measurements for the intended test tire. The data are suitable for use in determining parameters for road load models and for comparative evaluations of the measured properties in research and development.
This document was edited for clarity, to elucidate its relationship to SAE J2812, to replace the cross-sectional view of the mounted cleat, and to remove a time-sensitive statement about on-going research that is no longer applicable.
Research and development
Also known as: SAE J 2730
Subscribers can view annotate, and download all of SAE's content.
Learn More »