SAE International
SAE Standards Works
SAE International
Contact Us | Help | Shopping Cart
SAE Login

ARP4912C - Design Recommendations for Spare Seals in Landing Gear Shock Struts

Details
Not available for purchase at this time.
Document Number: ARP4912C
Project Initiation: 2013-08-30 09:02:24.0
Project Number:
Revision Number: C
Sponsor Name: Allan Burleigh
Title
Design Recommendations for Spare Seals in Landing Gear Shock Struts
Scope
<p>This SAE Aerospace Recommended Practice (ARP) provides recommendations on cavity design, the installation of elastomer type spare seals in these cavities, and information surrounding elastomer material properties after contact with typical shock absorber hydraulic fluid(s) or grease. This ARP is primarily concerned with the use of spare seals on shock absorbers where only a single dynamic seal is fitted and in contact with the slider/shock absorber piston at any one time.</p> <p>These shock absorbers typically have a spare (dynamic) seal gland located on the outer diameter of the lower seal carrier. This spare seal gland is intended to house a spare elastomer contact seal. Split Polytetrafluoroethylene (PTFE) backup rings can also be installed in the spare seal cavity.</p> <p>During operation, if the fitted dynamic shock absorber standard seal begins to fail/leak, then the aircraft can be jacked up, allowing the lower gland nut of the shock absorber to be dropped down. The current used dynamic seal can be cut free, and the spare elastomer seal can be stretched over the seal carrier ring into the dynamic seal position. The shock absorber can be re-assembled and then the landing gear is ready to continue operation with a new seal in position after this relatively simple procedure.</p>
Rationale
This document provides information surrounding the recommended hardware geometry for spare seals in landing gear shock struts, as well as the effects of stretch, fluid interaction, and grease interaction on elastomer seal properties. In addition, this ARP document now covers property characteristics of AMS-P-25732 and AMS-P-831461 elastomer materials after immersion in the three primary red oils (hydraulic fluids) used in industry, MIL-PRF-5606, MIL-PRF-87257, and MIL-PRF-83282. Changes in volume, tensile strength, and elongation are discussed after immersion in the aforementioned fluids, both in whole and in mixed percentages of fluid. These characteristics should be taken into account when incorporating and implementing fluid and/or fluid changes with specific elastomer materials in shock struts containing spare seals.
Recent Activity
DateType