SAE Standards Works
AMS D Nonferrous Alloys Committee
AMSQQA225/6B - Aluminum Alloy, 2024, Bar, Rod, and Wire; Rolled, Drawn, or Cold Finished
Not available for purchase at this time.
Aluminum Alloy, 2024, Bar, Rod, and Wire; Rolled, Drawn, or Cold Finished
This specification covers the specific requirements for 2024 aluminum alloy bar, rod and wire produced by rolling, drawing or cold finishing.
RATIONALE AMS-QQ-A-225/6B stabilizes this document because it is no longer state of the art and other documents contain technically equivalent requirements. STABILIZED NOTICE AMS QQ-A-225/6B has been declared "STABILIZED" by SAE AMS D Nonferrous Alloys Committee. This document will no longer be updated and may no longer represent standard industry practice. This document was stabilized because it is no longer state of the art and other documents contain technically equivalent requirements. Previously this document was reaffirmed. The last technical update of this document occurred in September, 1998. Users of this document should refer to the cognizant engineering organization for disposition of any issues with reports/certifications to this specification; including exceptions listed on the certification. NOTE: In many cases, the purchaser may represent a sub tier supplier and not the cognizant engineering organization. AMS Committee D recommends that the following technically equivalent specifications be used for future procurement. This listing does not constitute authority to substitute these specifications for the “STABILIZED” specification. AMS4120 Aluminum Alloy, Rolled or Cold Finished Bars, Rods, and Wire 4.4Cu - 1.5Mg - 0.60Mn (2024) Solution Heat Treated and Naturally Aged (T4) Solution Heat Treated, Cold Worked, and Naturally Aged (T351) AMS4339 Aluminum Alloy, Rolled or Cold Finished Bars and Rods 4.4Cu - 1.5Mg - 0.60Mn (2024- T851) Solution Heat Treated, Cold Worked, and Artificially Aged
. All rights reserved.
Intellectual Property Policy
Terms & Conditions