Search Results

A multi-coordinate FRF-based inverse substructuring approach is proposed to partition a vehicle system into two or more substructures, which are coupled at discrete interface points. The joint and free substructure dynamic characteristics are then extracted from the coupled system response spectra. Depending on the actual form of the structural coupling terms, three forms of the coupling matrix are assumed here. The most general one constitutes the non-diagonal form, and the other two simpler cases are the block-diagonal and purely diagonal representations that can be used to simplify testing process and overcome computational problems. The paper is focused on the investigation of the durability of these three formulations when the input FRFs are noise contaminated. A finite element model of a simplified vehicle system is used as the case study.

A spectral-based substructuring approach applying linear frequency response functions (FRF) is proposed for improving the accuracy of simulating the dynamics of coupled systems. The method also applies a least square singular value decomposition (SVD) scheme to overcome the inherent computational deficiency in the basic substructuring formulation. The computational problem is caused by the magnification of measurement errors during any one of the matrix inversion calculations required for this method. The primary objective of applying this approach is to examine the possibility of analyzing higher frequency response that is normally not possible using conventional modeling technique such as the direct finite and boundary element, and lumped parameter techniques. In this study, additional concepts are also evaluated to quantify the limitations and range of applicability of the proposed substructuring approach for simulating the vibration response of complex powertrain structures.

The natural modes of the ring gear structure commonly used in automotive transmissions are predicted using the finite element approach, and the sensitivities of these modes to boundary conditions between the housing and ring gear are analyzed. The specific boundary conditions of interest include free-free, simply-supports at equally spaced angular points, and discrete and distributed spring elements. For the free-free boundary condition, clear well-defined modes are observed that can be classified into four fundamental groups corresponding to radial inextensional, extensional, out-of-plane bending and pure torsional. However, when other boundary conditions are applied the mode shapes become more complex. For instance, in the simply-supported case the radial inextensional and torsional modes are seen to appear highly distorted. Also, the natural frequencies of these modes are higher than the free-free ones.

A simulation methodology for dynamic modeling of geared rotor systems such as superchargers was used for determining the housing vibration response. The approach provides an ability to make quick parametric design modifications to the model for evaluation of relative noise response with the assumption that the averaged housing vibration level correlates approximately to the noise radiating from the surface. The housing in some cases was modeled as a lumped mass representation for efficiency, and when higher accuracy of housing modes was needed, a detailed flexible Finite Element Analysis (FEA) representation was used. The interesting features of the methodology were the use of constraint equations to model the gear mesh response per unit Transmission Error (TE) input, along with summarizing the component kinetic and strain energy for each mode and the mesh compliance for fast evaluation of opportunities for noise reduction.