Search Results

The purpose of this work was to examine gasoline particle filters (GPFs) at high mileages. Soot levels for gasoline direct injection (GDI) engines are much lower than diesel engines; however, noncombustible material (ash) can cause increased backpressure, reduced power, and lower fuel economy. In this study, a post mortem was completed of two GPFs, one at 130,000 mi and the other at 150,000 mi, from two production 3.5L turbocharged GDI vehicles. The GPFs were ceramic wall-flow filters containing three-way catalytic washcoat and located downstream of conventional three-way catalysts. The oil consumption was measured to be approaching 23,000 mpqt for one vehicle and 30,000 mpqt for the other. The ash contained Ca, P, Zn, S, Fe, and catalytic washcoat. Approximately 50 wt% of the collected ash was non-lubricant derived. The filter capture efficiency of lubricant-derived ash was about 50% and the non-lubricant metal (mostly Fe) deposition rate was 0.9 to 1.2 g per 10,000 mi.

In the current paper, three dimensional fluid flow and pressure loss characteristics are investigated numerically for the geometry of a catalytic converter with two substrates inside. Various relative positions of two substrates are considered: air gap widths in the axial direction and different alignments of substrate's channels in the lateral direction. Studies are focused on the effects of those relative positions on flow uniformity inside both substrates and additional pressure loss through converter system. Under the same flow conditions and a constant air gap width, the stagger alignment in the lateral direction, shown in Fig. 1 (a), gives the highest additional pressure loss (pressure drop through air gap). Additional pressure loss drops with the increase of air gap width and reaches the lowest value at certain air gap width, then increases with the increases of gap width.