Search Results

The 3D Printing (3DP) technology due to its greatest strength, resistance to wear and corrosion to oxidizing agents and has good temperature resistance with durable one. The present article describes the effect of print orientation and infill density of 3DP route on mechanical and tribological properties of PETG filament. The 3DP parameters like layer thickness, slicing, speed, feed are kept as constant and by varying the print orientation (X, Y, Z) with infill density (50%, 75%, 100%) was printed to check the effect of it on mechanical and tribological properties like hardness, impact strength, ultimate tensile strength, flexural strength, wear rate and coefficient of friction. The results shows that all the tested mechanical and tribological properties increase by around 30-60% when the orientation is in the X direction at infill density of 100%.

The steering knuckle is an essential component in All-Terrain Vehicle (ATV) which withstands alternating loads subjected to different conditions without affecting the vehicle performance. The main objective of the proposed work was to design and analysis the steering knuckle under static conditions to observe stress, total deformation and factor of safety for proposed materials. In this present investigation, Aluminium alloy (AA7075) was chosen as it exhibits good ductility, high strength, toughness and high resistance to withstand impact load. The prime objective of this work was processed under three different conditions like virgin AA7075, AA7075 with T6 heat treatment and AA7075 with T6 heat treatment followed by shot-peening post processed technique was completed and to attain diverse strength of the samples were tested and noted appropriate responses. The secondary objective of our proposed work, an optimum knuckle design was modeled using Solidworks.

The restrictor is a component which controls the mass flow of air passing to the engine. The proposed work focuses on design and analysis of air intake restrictor of Duke 390cc engine which is used in formula vehicles. As an constrain of this system, the air flows through a single circular throat of diameter 20mm. In past decades conventional venture nozzles were used as a restrictor but it leads to nominal press drop. A de lavel nozzle is a tube pinched in the middle, making an asymmetric hourglass shape. It is used to accelerate a higher supersonic speed in the axial direction. The main objective is to utilize De-Laval Nozzle for the minimal pressure drop. The change in pressure will increases the engine power output. The analysis is done by varying design conditions such as three levels of convergent (12,14 and 16 degrees) and three levels of divergent angles (4, 6 and 8 degrees) are taken into consideration.