Search Results

Since the introduction of Euro IV legislation [1, 2], Selective Catalytic Reduction (SCR) technology using liquid urea injection is (one of) the primary methods for NOx reduction in many applications. Ammonia (NH3) is the reagent and key element for the SCR system and its control calibration to meet all operational requirements. TNO and Horiba are highly motivated to facilitate a correct interpretation and use of emissions measurement data. Different hypotheses were defined to investigate the impact of temperatures and flow rates on urea decomposition. These parameters are known to strongly affect the urea decomposition process, and thus, the formation of NH3. During a test campaign, different SCR catalyst feed gas conditions (mass flow, temperature, species and dosing quantities) were applied. Three Horiba FTIR gas analyzers were installed to simultaneously sample either all upstream or all downstream of the SCR brick. Both steady-state and dynamic responses were evaluated.

Recently, after-treatment techniques for diesel engine emission reduction have made a remarkable progress. Owing to new techniques such as the diesel particulate filter (DPF), the total amount of particulate matter (PM) collected on filter is rapidly reducing. It is significantly important for an engine operation to control the amount of PM or PM component ratio for high efficient after-treatment operation. Though a conventional gravimetric method is required by regulations, an alternative method, a combustion method, is focused on because of its simple and quick measurement. However it turned out that the combustion method has some difficulties to measure the low mass PM below 0.5mg. Then improvement methods were considered in this paper. Finally the modified instrument showed good correlation with gravimetric results below 0.5mg.