Search Results

The effects of lubricating oil on friction and wear were investigated using light-duty 2.2L compression ignition direct injection (CIDI) engine components for bench testing. A matrix of test oils varying in viscosity, friction modifier level and chemistry, and base stock chemistry (mineral and synthetic) was investigated. Among all engine oils used for bench tests, the engine oil containing MoDTC friction modifier showed the lowest friction compared with the engine oils with organic friction modifier or the other engine oils without any friction modifier. Mineral-based engine oils of the same viscosity grade and oil formulation had slightly lower friction than synthetic-based engine oils.

Engine design and tribology engineers are constantly challenged to develop advanced products with reduced weight, reduced friction, longer life, and higher engine operating temperatures. The resulting engine systems must also meet more demanding emissions and fuel economy targets. Advanced energy-conserving lubricants and surface coatings are concurrently evolving to meet the needs of new engine materials. Because of the enormous cost and time associated with engine testing, much interest is being focused on the development of representative and repeatable bench tests for evaluation of engine materials and lubricants. The authors have developed a bench test employing reciprocating motion for evaluating friction and energy-conserving characteristics of lubricants.

This paper presents an overview of techniques for measuring friction using bench tests and fired engines. The test methods discussed have been developed to provide efficient, yet realistic, assessments of new component designs, materials, and lubricants for in-cylinder and overall engine applications. A Cameron-Plint Friction and Wear Tester was modified to permit ring-in-piston-groove movement by the test specimen, and used to evaluate a number of cylinder bore coatings for friction and wear performance. In a second study, it was used to evaluate the energy conserving characteristics of several engine lubricant formulations. Results were consistent with engine and vehicle testing, and were correlated with measured fuel economy performance. The Instantaneous IMEP Method for measuring in-cylinder frictional forces was extended to higher engine speeds and to modern, low-friction engine designs.

Bench tests are often less expensive and faster than vehicle tests. However, correlation between bench tests and the engine needs to be proven, otherwise bench tests may be misleading. This investigation explored the relationships between bench wear test results and engine results from short-trip driving tests for a variety of conditions: fresh vs. used oil, different methods for assessing wear, and chemical effects such as oil contamination and differences in the fuel. There was a negative correlation between bench tests with fresh oil compared to vehicle test results with used oil, which suggests that bench wear characteristics of fresh engine oil should not be used to determine engine wear rates under the conditions tested here. Statistical analysis of bench test wear rates with used engine oil, compared to engine wear measurements, indicated that the trends were in an appropriate direction, with some scatter in the results.

The impacts of cylinder bore surface finish and coating treatment on the tribological characteristics of engine components were determined by using a modified Cameron-Plint Friction and Wear Tester. The friction and wear behavior of several honed cylinder bores was compared using plateau-honed and brush-honed bores in a normal, lubricated sliding wear mode. Several experimental thermal sprayed aluminum bores, prepared following a water jet cleaning process, were compared to production cast iron plateau-honed bores. For the cast iron bores, it was observed that most of the wear occurred within the first 2 hours of the run-in stage. In general, the combination of a cast iron bore sliding against molybdenum sprayed piston rings showed lower friction and wear compared to the thermal spayed aluminum bore samples sliding against the same rings. The rough-honed bore samples demonstrated much higher wear than the plateau-honed or brush-honed bores.