Search Results

With the aim of producing innovative clutch actuation mechanisms for automotive transmissions, we are investigating a design based on power screws. The design strives to improve clutch actuation technology and minimize energy consumption by maintaining clutch lock-up independent of an external energy source. The system consists of a lead screw shaft-and-nut assembly, a clutch apply-plate, a set of wet clutch disks and a brushless DC motor. The clutch actuation assembly is separated from the clutch-pack via thrust bearings, which allows the use of a motor, while reducing the inertial load imposed by the conventional clutch-pack. A prototype of the design was fabricated and installed on a testbed, to mimic the installation of the actuator to replace the hydraulic components. A standard 12-disk clutch-pack of an automatic transmission was used within the apparatus. The formulation of the mathematical model of the entire testbed is described in this paper.

In a parallel hybrid electric vehicle, higher fuel economy gains are typically achieved if significant electric drive (or engine-off) operation is possible, shifting the engine operating schedule so that it only runs at medium to high load for best efficiency. To enable efficient engine-off driving, a typical configuration will have a disconnect clutch between the engine and the rest of the driveline. In some configurations, when engine-on operation is requested the disconnect clutch is applied in conjunction with the traction motor/generator to crank the engine (i.e., a flying engine start). In this paper we describe the development of a control system for a flying engine start using an engine disconnect clutch. The clutch is located between the engine and electric motor, which is connected to the input of a multispeed transmission. We first describe an initial control algorithm evaluation using a driveline model.