Search Results

Supercharger gear whine noise has been a NVH concern for many years, especially around idle rpm. The engine masking noise is very low at idle and the supercharger is sensitive to transmitted gear whine noise from the timing gears. The low loads and desire to use spur gears for ease in timing the rotors have caused the need to make very accurate profiles for minimizing gear whine noise. Over the past several years there has been an effort to better understand gear whine noise source and transmission path. Based on understanding the shaft bending mode frequencies and better gear design optimization tools, the gear design was modified to increase the number of teeth in order to move out of the frequency range of the shaft bending modes at idle speed and to lower the transmission error of the gear design through optimization using the RMC (Run Many Cases) software from the OSU gear laboratory.

The spur timing gears in Eaton superchargers operate at low torque loads and the supercharger system is especially sensitive to gear whine noise created by minute differences in the spur gear tooth profile quality. This has necessitated the grinding of very high quality profiles on high-contact-ratio spur gears. The manufacturing operation has used subjective evaluation of profile and lead measurements to qualify grinder diamonds and audit gear quality related to noise. They have also relied on supercharger end-of-line-testers to provide a direct measurement of gear noise as the primary quality feedback to the gear manufacturing process. Since the difference in the inspection plots of very high quality profiles is difficult to determine subjectively, the inspection process assessments have been difficult to correlate to the resultant gear noise measurements.

Helical gears are commonly used instead of spur gears due to their potential higher load carrying capacity, efficiency and lower noise. Transmission Error (TE) is defined as deviation from perfect motion transfer by a gear pair. TE is dominant source of gear whine noise and hence gears pairs are generally analyzed and designed for low TE. In the process of designing helical gears for lower TE, the shuttling moment can become a significant excitation source. Shuttling moment is caused due to shifting of the centroid of tooth normal force back and forth across the lead. The amount of shuttling force or moment is produced by combination of design parameters, misalignment and manufacturing errors. Limited details are available on this excitation and its effect on overall noise radiated from gear box or transmission at its gear mesh frequency and harmonics.

Extensive experimental and numerical investigations were done to improve the vibration and acoustic performance due to excitation at the timing gears of automotive supercharger. Gear excitation, system response, and covers have been studied to find the most cost efficient method for reducing gear whine noise. Initially, gear excitation was studied where it was found that transmission error due to profile quality was the dominant source parameter for gear whine noise. To investigate the system effects on gear noise, a parametric study was carried using FEM model of the supercharger, with special interests in optimizing dynamic characteristics of internal components and the coupling to supercharger housing. The BEM model of the corresponding supercharger was built to predict the noise improvement after dynamic optimization of the system. Good correlations were observed between experimental and numerical results in both dynamic and acoustic parameters.

Supercharger timing gears have been a source of rattle noise due to torsional vibration from the engine and sometimes have required torsional isolators to reduce the rattle noise significantly. Supercharger gear rattle is studied analytically and experimentally in this paper in order to understand to what extent basic design parameters could impact gear rattle noise to eliminate the need for isolators. A 3 DOF (degree of freedom) discrete model is used to represent a geared rotor system in the supercharger. A mathematical dynamic model is established in Matlab handling the non-linearity due to gear backlash. The fluctuation of input torque is used as source of excitation. A real time simulation technique is used for the analysis. Good correlation has been obtained between the experimental and analytical results. An index for comparing analytical results to gear noise and vibration level has been proposed.