Search Results

NOx and PM are the critical emissions to meet the legislation limits for diesel engines. Often a value for these emissions is needed online for on-board diagnostics, engine control, exhaust aftertreatment control, model-based controller design or model-in-the-loop simulations. Besides the obvious method of measuring these emissions, a sensible alternative is to estimate them with virtual sensors. A lot of literature can be found presenting different modeling approaches for NOx emissions. Some are very close to the physics and the chemical reactions taking place inside the combustion chamber, others are only given by adapting general functions to measurement data. Hence, generally speaking, there is not a certain method which is seen as the solution for modeling emissions. Finding the best model approach is not straightforward and depends on the model application, the available measurement channels and the available data set for calibration.

Modern ECUs are usually torque orientated. As a consequence, a good estimation of the real mean value output torque of the engine is needed. As torque measurement is mostly too expensive, the ECUs usually include torque estimation algorithms, which, however, are usually quite simple and give a poor estimate of dynamic effects. In this paper we present a simple but effective method to estimate the engine torque based on an extended Kalman filter used in combination with a polynomial engine model and a simple friction model. Using only standard measurements or ECU internal variables, like fuel mass, spark advance for gasoline engines and injection timing for diesel engines, pressure of the intake manifold and speed are enough to get a good estimation value for the mean value torque of the engine. In this paper we also discuss the algorithm of estimating the mean value torque of the engine that is mounted in a vehicle, where usually the load torque is not known.

This paper presents a detailed optical and thermodynamic analysis of effects which influences the soot formation and oxidation process during Diesel combustion. To measure the actual soot concentration over crank angle an optical sensor was installed on the engine. In combination with a thermodynamic engine process calculation, based on the measured cylinder pressure, several important effects are analyzed and described in detail. The main focus of the paper is to produce knowledge on how soot dynamics is influenced by changed engine control unit (ECU) calibration parameters. A modern 4 cylinder production car Diesel engine was used for the studies, which offers a lot of opportunities to influence combustion by varying injection timing and air path ECU parameters. As a consequence discussion is done on how the analyzed effects are treated by published 0-dimensional simulation models with focus on later control and optimization application.