Search Results

Crankshaft is a dynamic component that copes with elevated alternating stresses. In order to ensure the service reliability, fillet rolling process is being applied. The state of the art empirical assumptions to consider the effect of fillet rolling process on crankshaft fatigue are conservative. This leads to an over-engineering of the crankshaft. However, calculation of the compressive residual stresses due to surface treatment is a demanding task. The quality of the durability analysis can only be increased by an accurate consideration of the fillet rolling effect. Therefore, Hegenscheidt-MFD, FEV Motorentechnik and Institute for Combustion Engines (VKA) cooperated to enlighten the phenomenon of the fillet rolling process. Process calculations are applied and validated by the measurements and tests. The calculated residual stresses are then superposed with the dynamic loads calculated by FEV Virtual Engine.

Due to the rapidly increasing raw oil price the reduction of fuel consumption has become one of the most important targets for the development of modern passenger car engines. After large progress has been achieved in the combustion process development - CAE has been one of the keys to success - nowadays further potential is being investigated. The mechanical friction is very much in the focus of the engine development engineers. While in the Valve Train the potential of roller contacts and surface treatment is the main development direction, in the cranktrain the reduction of bearing diameters is being investigated. Due to increasing specific loads on the crankshaft there are clear limits. At the piston group the potential is almost untouched. While optimizations of the piston skirt contour or the ring pack bring up the risk of negative influences on blow by and oil consumption, the application of a crank offset is an easy design measure having almost no risks.

The loads on the plain bearings of modern combustion engines increase continuously. Reasons for this development are increasing engine speeds on gasoline engines, growing cylinder peak pressures at diesel engines and both combined with the steady trend toward light weight concepts. The still significantly increasing power output of modern engines has to be combined with actions reducing the engine friction losses, as for example smaller bearing dimensions or lower engine oil viscosities. At the same time the comfort, lifetime and engine service interval targets are aggravating boundary conditions. This development leads to the point, where former approaches toward plain bearing layout reach their systematic limitations - a first indication are bearing failures, which occur even though all conventional layout criteria's are fulfilled. Further effects need to be considered to simulate the behavior of the plain bearing under the boundary conditions of a fired combustion engine.