Search Results

The formation and breakup of diesel sprays was investigated experimentally on a common rail diesel injector using a long range microscope. The objectives were to further the fundamental understanding of the processes involved in the initial stage of diesel spray formation. Tests were conducted at atmospheric conditions and on a rapid compression machine with motored in-cylinder peak pressures up to 8 MPa, and injection pressures up to 160 MPa. The light source and long range imaging optics were optimized to produce blur-free shadowgraphic images of sprays with a resolution of 0.6 μm per pixel, and a viewing region of 768x614 μm. Such fine spatial and temporal resolutions allowed the observation of previously unreported shearing instabilities and stagnation point on the tip of diesel jets.

The influences of injector nozzle geometry, injection pressure and ambient air conditions on a diesel fuel spray were examined using back-lighting techniques. Both stills and high speed imaging techniques were used. Operating conditions representative of a modern turbocharged aftercooled HSDI diesel engine were achieved in an optical rapid compression machine fitted with a common rail fuel injector. Qualitative differences in spray structure were observed between tests performed with short and long injection periods. Changes in the flow structure within the nozzle could be the source of this effect. The temporal liquid penetration lengths were derived from the high-speed images. Comparisons were made between different nozzle geometries and different injection pressures. Differences were observed between VCO (Valve Covers Orifice) and mini-sac nozzles, with the mini-sac nozzles showing a higher rate of penetration under the same conditions.

As part of an ongoing investigation, the influence of in-cylinder charge density, and injector nozzle geometry on the behaviour of diesel sprays were examined using high-speed imaging. Both liquid and vapour penetration profiles were investigated in operating conditions representative of a modern turbocharged after-cooled HSDI diesel engine. These conditions were achieved in an optical rapid compression machine fitted with a common rail fuel injection system. Differences in spray liquid and vapour penetrations were observed for different nozzle geometries and in-cylinder conditions over a range of injection fuelling representative of those in a typical engine map. Investigation into the differences in spray structure formed by multi-hole and single-hole injections were also undertaken.

The temperature of fuel injectors can affect the flow inside nozzles and the subsequent spray and liquid films on the injector tips. These processes are known to impact fuel mixing, combustion and the formation of deposits that can cause engines to go off calibration. However, there is a lack of experimental data for the transient evolution of nozzle temperature throughout engine cycles and the effect of operating conditions on injector tip temperature. Although some measurements of engine surface temperature exist, they have relatively low temporal resolutions and cannot be applied to production injectors due to the requirement for a specialist coating which can interfere with the orifice geometry. To address this knowledge gap, we have developed a high-speed infrared imaging approach to measure the temperature of the nozzle surface inside an optical diesel engine.