Search Results

Engine calibration involves the interaction of electronic components with various engine systems like intake system, exhaust system, ignition system, etc. Emissions are the by-products of combustion of fuel and air inside the combustion chamber. After-treatment systems generally take up the responsibility to scrape out harmful emissions from the engines. However, a good engine calibration will focus on emission reduction at source i.e., during the combustion itself. Thus, the intake of air and fuel in proper amount at each engine operating point is crucial for optimized engine performance and minimal emissions. The Intake system is an integral part of any internal combustion engine and it plays an important role to improve its performance and emission. Generally, for a SI engine, maintaining the stoichiometric A/F ratio is a challenging endeavour from an operational standpoint.

CNG has recently seen increased penetration within the automotive industry. Due to recent sanctions on diesel fuelled vehicles, manufactures have again shifted their attention to natural gas as a suitable alternative. Turbocharging of SI engines has seen widespread application due to its benefit in terms of engine downsizing and increasing engine performance [1]. This paper discusses the methodology involved in development of a multi cylinder turbocharged natural gas engine from an existing diesel engine. Various parameters such as valve timing, intake volume, runner length, etc. were studied using 1D simulation tool GT power and based on their results an optimized configuration was selected and a proto engine was built. Electronic throttle body was used to give better transient performance and emission control. Turbocharger selection and its location plays a critical role.

The design and development of a hydrogen powered spark-ignition engine, aimed for installation on a vehicle for on-road application. The experiment was conducted at WOT (Wide Open Throttle) condition at a speed of 4000 rpm with an excess air-fuel ratio of 1.3, 1.5, 2.2, 2.5, 3, 3.75, and 4.0. The ignition timing was optimized for maximum torque at each value of the excess air ratio. The various parameters analyzed such as in-cylinder pressure, Pressure and Volume, Logarithm of Pressure and Volume, Mass fraction burned, Cummulative heat release, Net heat release, Rate of pressure rise, and Mean gas temperature. The results show that there is a profound effect of excess air-fuel ratio on the engine’s mean effective pressure, output power, Brake thermal efficiency, Volumetric efficiency, Brake specific fuel consumption, and NOx emissions. The peak cylinder pressure decreases with an increase in excess air-fuel ratio and NOx emissions are reduced due to reduced mean gas temperature.