Search Results

This paper discusses the analysis and measurement of the dynamic centre of pressure of a brake pad during a normal braking event. The technique is unique in its design and implementation. The process is progressive whereby the interface static measurements are first taken and then dynamic testing is carried out under braking. Two different measurement systems are considered during the analysis with one used to measure the center of pressure. Both the in-board and out-board pads are measured for wear but the piston pad was selected for pressure measurements. Validation of the spragging process is undertaken on both test rigs and vehicle trials. Pad wear measurements complement the collective information. The results show the position of the centre of pressure to vary considerably during a braking event, both radially and axially along the pad.

Pressure sensitive film embedded into the body of a pad friction compound is a unique technique used to measure the dynamic centre of pressure at the pad/disc interface during a normal braking operation. This paper uses of a modified 12 piston opposed caliper where the initial centre of pressure may be varied both along the pad and radially. Results show a very definite movement of the centre of pressure towards the centre of the pad as the brake pressure is increased. In addition it is seen that a leading centre of pressure (CoP) will result in noise whereas a trailing CoP gives a quiet brake. Equally a CoP towards the inner edge of the pad increases noise propensity whereas towards the outer edge a quiet brake. The results also show little influence on the CoP with disc speed.