Search Results

Both in conventional diesel combustion and the low temperature combustion represented by PCCI and EGR-diluted combustion, high mixing rate at the whole combustion history is the key to achieve comparative clean and high-efficiency combustion. In this study, a newly developed combustion chamber, vortex-induced combustion chamber which can enhance middle and late cycle combustion is developed based on BUMP combustion chamber investigated in previous study. And then, the combustion and emission characteristics in the circumstances of diluted combustion are studied. For low oxygen concentration cases, heat release rate goes down and combustion efficiency decreases due to decreased mixing efficiency. The results of chamber design indicate complex structure of flow can be realized by special designed chamber geometry. The velocity difference in the interface of the vortexes will benefit to mixing of fuel and air, therefore combustion and emissions.

Diesel-fueled HCCI combustion was achieved by multi-pulse injection before top dead center (TDC). However, the multi-pulse injections strategies have not been sufficiently studied previously due to the large number of parameters to be considered. In the present work, a series of multi-pulse injection modes with four or five pulses in each mode are designed, and their effects on diesel HCCI Combustion are experimentally studied. The results showed that the HCCI diesel combustion was extremely sensitive to injection mode. There were many modes to achieve very low NOx and smoke emissions, but the injection parameters of these modes must be optimized for higher thermal efficiency. A micro-genetic algorithm coupled with a modified 3D engine simulation code is utilized to optimize the injection parameters including the injection pressure, start-of-first-injection timing (SOI), fuel mass in each pulse injection and dwell time between consecutive pulse injections.

A concept of high density-low temperature combustion (HD-LTC) is put forward in this paper, showing potential of its high thermal efficiency and very low engine-out emissions by engine experimental and CFD modeling study. A single cylinder test engine has been built-up equipped with mechanisms of variable boost pressure and intake valve closing timing (IVCT). By delaying IVCT and raising boost pressure to certain values according to engine loads, the in-cylinder charge density is regulated much higher than in conventional engines. It is found that the high charge density can play the role of rising of heat capacity as exhaust gas recirculation (EGR) does. Thereby low temperature combustion is realized with less EGR (about 18~19% oxygen concentration) to achieve very low NOx and soot emissions, which is extremely important at high and full loads.