Search Results

In order to understand the spray impinging the lubricant oil on the piston or cylinder wall in GDI engine, the Laser Induced Fluorescence (LIF) method was used to observe the phenomenon of the fuel droplets impact oil film and distinguish the fuel and oil during the impingement. The experimental results show that the hydrodynamic characteristics of impingement affected by the oil viscosity, droplets’ Weber number, oil film thickness. Crown formed after impingement. The morphology after impingement was categorized into: rings, stable crown, splash and prompt splash. Low oil film dynamic viscosity, high Weber number or thin oil film can facilitate splash. Splash droplets consist of fuel and oil, and the oil is the main component of splash droplets and crown. The empirical formula of critical We number (We) is fitted. High dimensionless oil film thickness or low oil film dynamic viscosity can increase the proportion of fuel in the crown.

The aim of this research is to experimentally investigate the effects of combustion parameters [ignition timings, injection timings, excess air ratio (λ)] and lubricating oil on particulate matter (PM) emissions from a 2.0 L turbo-charged gasoline direct injection (T-GDI) engine fueled with gasoline (octane number = 97), methanol/gasoline blends and pure methanol. The results of this paper show that the PM number concentration mostly presents a typical bimodal distribution in figures. The particle number concentration mainly concentrates in the nucleation mode. With the increase of methanol volume fraction in the blended fuel, the PM emissions decrease significantly. Furthermore, there are few particles when the engine fueled with pure methanol. As advancing ignition timing, the total PM number rises by over about 200%. Under the pre-ignition condition, the higher in-cylinder temperature may also accelerate the formation of the nucleation mode particles.