Search Results

The usage of alternative fuels inside internal combustion engines (ICE), is one promising approach to meet the higher requirements concerning the efficiency and emission of modern combustion systems. The injection and mixture formation of such fuels has a major impact on the subsequent combustion as well as the formation of pollutants. To rate the influence and to gain a better understanding of those new alternatives a basic understanding of these dominant processes is mandatory. The principle of laser-induced fluorescence (LIF) is a well-known method to display and evaluate fuel distributions inside combustion chambers. A suiting online calibration routine allows the visualization of air-fuel equivalence ratio (λ) two-dimensionally during different operation modes. As cyclic variations can become a more critical issue while using alternative fuels, cycle- resolved test series become more and more important.

This work capitalizes on the investigation of the effect of split injection on the combustion and in-cylinder soot formation performance of low Compression Ratio GTL-fueled DI diesel engine. An optically-accessed Rapid Compression Machine was deployed allowing the application of optical diagnostics. A shadowgraph imaging was used to analyze spray development and detect ignition zones while imaging of soot incandescence was used to determine the temporal and spatial development of soot. In addition the rate of heat release was calculated for the analysis of the combustion characteristics. It has been found that split injection shortens sprays length while increases their penetration velocity. It alters the combustion from fully premixed to two-mode, premixed and non-premixed. Soot with split injection was, therefore, significantly larger while combustion noise was reduced by factor of 4.

Diesel particulate filters are effective devices to remove particulate matter from the diesel exhaust and to fulfill emission standards. However, the operating behavior is crucially influenced by the characteristics of the deposited and accumulated soot and ash, which is affected by different diesel engine operating parameters. This is especially relevant for the thermal control of the regeneration process that poses a challenge resulting from the lack of knowledge concerning the operation behavior of the filter. Within this study, the regeneration behavior of diesel particulate filters with several age-related states is compared. For that purpose, filters were aged with an accelerated method. These filters were loaded with different steady state conditions at the engine test bench. The subsequent regeneration was applied via post-injection. Therefore, it was possible to investigate the influence of different ash levels on the regeneration behavior of the filter.