Search Results

Crankshaft is one of the critical components of an engine (5C: cylinder head, connecting rod, crankshaft, camshaft and cylinder block). It is subjected to repetitive and dynamic loads due to cyclic operation of an engine and inertia forces. Due to uneven mass distribution, failure zones occur near fillets and holes in journal locations during operation of the engine. Hence, this topic was chosen because of increasing interest in higher payloads, lower weight, higher efficiency and shorter load cycles in crankshaft equipment. Calculation of Crankshaft strength consists initially in determining the nominal alternating bending and nominal alternating torsional stresses, which multiplied by the appropriate SCF (Stress Concentration Factor), result in an equivalent alternating stress. This equivalent alternating stress is then compared with the fatigue strength of the selected crankshaft material. This comparison will show whether or not the crankshaft concerned is dimensioned adequately.

A Coupled CFD - FE Analysis, referred as Conjugate Heat Transfer (CHT) Analysis or Fluid Structure Interaction (FSI), is very important for the processes that involves simultaneous energy exchange between solid and fluid domains. If we consider IC engines, Exhaust Manifold is one of the critical areas where above mentioned phenomenon takes place. In this paper, temperature distribution in solid parts of exhaust manifold is obtained through Computational Fluid Dynamics (CFD) analysis which uses Finite Volume Method (FVM) for solving Navier-stokes equation and energy equation. Whereas thermal stresses are predicted through FE analysis which is based on Finite Element Methods (FEM). It is obvious to validate CFD process before evaluating thermal stress. Therefore initially CFD results are compared with experimental results and found more than 88% correlation. Thereafter in FE analysis, temperature field from CFD is mapped to nodes of FE model and thermo-mechanical stresses are evaluated.

Advanced Non-linear topology optimization methods have been addressed as the most promising techniques for light weight and performance design of Powertrain structures. The theoretical achievements are obtained both mechanically and mathematically. Nowadays, the great challenge lies in solving more complicated engineering design problems with multidisciplinary objectives or complex structural systems. The purpose of this paper is to provide a forum to present new developments in structural Non-linear topology optimization. The advantage of the proposed method is that structural optimization on irregular design domains can be carried out easily. Furthermore, this method integrates the stress analysis and the boundary evolution within the framework of finite element methods. In this paper, mainly focused on the Commercial Vehicles Powertrain component i.e. Transmission Housing.

To compete with the current market trends there is always a need to arrive at a cost effective and light weight designs. For Commercial Vehicles, an attempt is made to replace existing Gear Shift Fork from FC Iron (Ferro Cast Iron) to ADC (Aluminum Die Casting) without compromising its strength & stiffness, considering/bearing all the worst road load cases and severe environmental conditions. ADC has good mechanical and thermal properties compared to FC Iron. Feasible design has been Optimized within the given design space with an extra supporting pad for load distribution. Optimization, Stiffness, Contact pattern has been done using OptiStruct, Nastran & Ansys for CAE evaluation. A 6-speed manual transmission is used as an example to illustrate the simulation and validation of the optimized design. Advanced linear topology optimization methods have been addressed as the most promising techniques for light weighting and performance design of Powertrain structures.