Search Results

Earlier publications have demonstrated that pad and disc properties change during storage and also during the SAE J2522 Brake Effectiveness Test Procedure. The current investigation was undertaken to find out how the properties change under milder braking conditions, using the SAE J2707 Wear Test Procedure. A copper-free formulation was selected for the investigation and tested on an inertia dynamometer using a front caliper designed for a passenger car. The pad dynamic modulus changed up or down throughout the test, depending on the test conditions. The pad dynamic modulus, the pad natural frequencies and the disc natural frequencies all decreased by the end of the test. Under high-speed, high-deceleration and high-temperature braking conditions, the pad surface region permanently expands, which results in reduced dynamic modulus and also leads to reduced pad thickness loss as compared with pad weight loss.

In a previous investigation, brake squeal was found to be related to disc wear, but not to pad wear or in-stop average coefficient of friction as tested according to the SAE J2522 performance procedure, using Low-Copper NAOs. To further validate the disc wear - squeal correlation, a variety of formulations of No-Copper, Low-Copper and High-Copper NAO disc pads were made and tested to investigate friction, pad wear, disc wear, brake squeal and wheel dust formation. It is found that disc weight loss measured at the end of the burnish cycle of the SAE J2522 (AK Master) is closely related to dynamometer/vehicle brake squeal and vehicle wheel dust formation, and that there is a critical disc wear rate of approximately 1.0 grams for the current brake system, below which brake squeal and wheel dust are minimal.

Copper-free disc pads of 9 different compositions were made using a traditional hot molding process and tested to study frictional behavior. It is found that the friction coefficient consists primarily of two parts; one part controlled by the plastic deformation of the friction surface region of the disc and pad, and the second part controlled by the total wear of the disc and pads. As the plastic deformation and the wear are non-linear with respect to the load and sliding speed, the friction coefficient becomes a non-linear function of the load and speed. Under moderate braking conditions, the plastic deformation part is more significant in determining the friction coefficient while under more severe braking conditions, the wear contribution becomes more significant. The frictional behavior of a fade cycle is explained, and the correlation between brake squeal and disc wear is confirmed.

There is anecdotal evidence that disc pad wear numbers measured in thickness loss and disc pad wear numbers measured in weight loss do not show the same wear trends after wear or performance testing. However, research papers on this topic are difficult to find. Therefore, this investigation was undertaken to study and document this behavior in detail on high-copper, low-copper and no-copper (or copper-free) NAO pads. In all cases, thickness loss measurements are found to be substantially lower than expected from the weight loss data according to the SAE J2522 test schedule. This divergence is caused by pad swelling in the pad layer adjacent to the friction contact surface during brake testing at high temperatures. In addition to formulation changes, disc pad processing conditions such as mixing time and hot molding pressure are found to affect pad swelling.