Search Results

The traditional diesel engine suffers from high emission levels of nitrogen oxide and particulate matter. A new injection concept has therefore been developed and investigated. To enhance the air-fuel mixing process and avoid local concentration of fuel, the injection direction of each spray is varied during the injection event. This was achieved by rotating the injector. In this test, the rotational speed was 1700 rpm. On a six-cylinder engine, one cylinder was equipped with the new injector and exhaust gases were sampled with a new type of valve, integrated in the exhaust-valve stem of the affected cylinder. Tests show that the combustion is significantly affected by the rotating injection. The impact of the rotating injection on smoke, emissions and heat release was repeatable but dependent on loadpoint. No universal trend over all loadpoints was found. NO levels were mostly lowered but for smoke and CO, both lower and higher levels than without rotation were encountered.

In-cylinder flow measurements, conventional swirl measurements and CFD-simulations have been performed and then compared. The engine studied is a single cylinder version of a Scania D12 that represents a modern heavy-duty truck size engine. Bowditch type optical access and flat piston is used. The cylinder head was also measured in a steady-flow impulse torque swirl meter. From the two-dimensional flow-field, which was measured in the interval from -200° ATDC to 65° ATDC at two different positions from the cylinder head, calculations of the vorticity, turbulence and swirl were made. A maximum in swirl occurs at about 50° before TDC while the maximum vorticity and turbulence occurs somewhat later during the compression stroke. The swirl centre is also seen moving around and it does not coincide with the geometrical centre of the cylinder. The simulated flow-field shows similar behaviour as that seen in the measurements.