Search Results

The market share of Gasoline Direct Injection (GDI) vehicles has been increasing, promoted by its positive contribution to the overall fleet fuel economy improvement. It has however been reported that this type of engine is emitting more ultrafine particles than the Euro 6c Particle Number (PN) limit of 6·1011 particles/km that will be introduced in Europe as of September 2017 in parallel with the Real Driving Emission (RDE) procedure. The emissions performance of a Euro 6b GDI passenger car was measured, first in the OEM build without a Gasoline Particulate Filter (GPF) and then as a demonstrator with a coated GPF in the underfloor position. Regulated emissions were measured on the European regulatory test cycles NEDC and WLTC and in real-world conditions with Portable Emissions Measurement Systems (PEMS) according to the published European RDE procedure (Commission Regulation (EU) 2016/427 and 2016/646).

The gap between diesel vehicle emissions in laboratory tests compared to those in use has been addressed by the introduction of the Real Driving Emissions (RDE) requirements. Modern diesel technology now demonstrates low emissions on the road over a wide range of driving conditions. This paper further demonstrates that consistent low nitrogen oxide (NOx) and particle number (PN) emissions can be achieved over a wide range of driving conditions beyond Euro 6d RDE requirements, with emission control technologies combined in an integrated approach. An LNT (Lean NOx Trap) is combined with a dual-dosing SCR (Selective Catalytic Reduction) system. Low-load NOx control is achieved by the LNT in combination with a close-coupled SCR coated on the Diesel Particulate Filter (SDPF). High load conditions, on the other hand, are covered by the underfloor SCR system with a second AdBlue® injector.

The electrified internal combustion engine can contribute to further improving air quality and reducing impact on climate change. A previous publication looked into ultra-low initial cold-start emissions with the implementation of a state-of-the-art emission control system on a gasoline vehicle with market E10 gasoline. This paper reports additional investigations on different drop-in sustainable renewable fuels, including e-fuels. The gasoline demonstrator vehicle is equipped with a 48V mild-hybrid powertrain with a 1.5 L direct injection engine. The innovative emission control system consists of an electrically pre-heated catalyst (EHC) and first three-way catalyst (TWC) in close-coupled position, in combination with an underfloor catalysed gasoline particulate filter (cGPF), second TWC and ammonia slip catalyst (ASC). Pollutant emission tests are conducted on a challenging chassis dyno test for cold-start emissions at 23 °C and -10 °C.