Search Results

Due to several market demands of higher wear and scuffing resistance, Duplex PVD (Physical Vapor Deposition) CrN top ring has been used in Heavy Duty Diesel (HDD) engines. The ring comprises a nitrided high chromium stainless steel with a PVD ceramic CrN coating. For High Speed Diesel (HSD) vehicles with lower demands, MAHLE has developed an alternative PVD coated ring, which balances the cost and performance ratio. This alternative, named High Value PVD (HV-PVD), consists of applying the best resistant coating for wear and scuffing, PVD, onto a less costly ring material, Ductile Cast Iron. The HV-PVD top ring has been tested in HSD engines and shown excellent performance. Additional advantages of the HV-PVD are its lower friction coefficient and better tribological compatibility with the cylinder bore materials when compared to the traditional galvanic chrome based coatings. Such features lead to reduced engine friction and lower cylinder wear.

The cylinder bore honing quality is an essential factor for a good engine performance and durability. A bad surface finish can result in an excessive lubricant oil consumption, high piston ring wear and scuffing occurrence. In this paper the most important characteristics of bore honing for cast iron cylinders and their influence in the combustion engine performance are described and discussed. Despite its importance, the bore honing is commonly undervalued due to various reasons including the difficulty of a practical but sufficient method of quality qualifying. Some honing commonly misunderstood concepts are detailed and SEM photographs of bore surface from both good and bad finish are presented. At the end of this paper it is also presented a recommendation for a practical evaluation method of honing quality.

The evolution of internal combustion engines has led to friction reduction as well as to gaseous emissions reduction, demanding the use of narrower rings. Nodular cast iron is used satisfactorily for compression piston rings, with wear resistant coatings to improve their durability. However, for more severe applications and rings narrower than 1.2mm, even the nodular cast iron mechanical resistance is not enough. In this way, the use of steel is recommended, which may have its tribological properties improved by the nitriding thermochemical treatment. This paper presents the characteristics of the materials and of the nitriding process of compression and oil control rings as well as bench and dynamometric test results run during the development of these products.

Engine developments have led to higher mechanical and thermal loads on the components, at the same time that lower friction losses are also sought. Therefore, the development of better materials and of surface treatments has received great emphasis. This paper presents the results of dynamometric engine tests with a proposed piston ring pack, composed of a gas nitrided steel top ring, a nitrided gray cast iron second ring and a normal production chrome plated oil ring. The proposed pack showed very low wear when applied to a medium duty diesel engine, besides being a cost-effective alternative to the conventional pack with moly coated and chrome plated (respectively in the top and second) rings. The proposed pack also caused very low wear on the cylinder bore, specially near the TDC, where the bore wear is usually maximum.

This work compares the typical manufacturing process of cast iron piston rings with chromium or molybdenum coating with the more recent nitriding steel process. Environmental impact of the processes is estimated by their material losses, consumption of energy and hazardous waste. Despite all technological development, the nowadays production process of a typical piston ring still implies that the finished part has only 30% of the iron initially cast. A more recent design, nitrided steel piston ring, reduces substantially material losses during the part manufacturing. It also substitutes high polluter processes as chromium plating or metal spray for the lower polluter gas nitriding. Production of Nitrided Steel Rings (NSR) uses 40% less energy, needs 78% less raw material and produces almost 10 times less hazardous waste. NSR has significant lower environmental impact in comparison with the traditional Coated Iron Ring (CIR). NSR also has environmental advantages during use.