Search Results

Experimental data have been obtained that characterize knock occurrence times and knock intensities in a spark ignition engine operating on indolene and 91 primary reference fuel, as spark timing and inlet temperature were varied. Individual, in-cylinder pressure histories measured under knocking conditions were conditioned and averaged to obtain representative pressure traces. These averaged pressure histories were used as input to a reduced and detailed chemical kinetic model. The time derivative of CO concentration and temperature were correlated with the measured knock intensity and percent cycles knocking. The goal was to evaluate the potential of using homogenous, chemical kinetic models as predictive tools for knock intensity.

Validation of the Ford General Engine SIMulation program (GESIM) with measured firing data from a modified single cylinder Ricardo HYDRA research engine is described. GESIM predictions for peak cylinder pressure and burn duration are compared to test results at idle operating conditions over a wide range of valve overlap. The calibration of GESIM was determined using data from only one representative world-wide operating point and left unchanged for the remainder of the study. Valve overlap was varied by as much as 36° from its base setting. In most cases, agreement between model and data was within the accuracy of the measurements. A cycle simulation computer model provides the researcher with an invaluable tool for acquiring insight into the thermodynamic and fluid mechanical processes occurring in the cylinder of an internal combustion engine.

A computer simulation for the performance of a four-stroke spark-ignition engine is used to assess the effects of in-cylinder flow processes on engine efficiency. The engine simulation model is a thermodynamic model coupled to submodels for the various physical processes of in-cylinder swirl, squish and turbulent velocities, heat transfer and flame propagation. The swirl and turbulence models are based on an integral formulation of the angular momentum equation and a K-ε turbulence model, These models account for the effects of changes in geometry of the intake system and the chamber design on in-cylinder flow processes. The combustion model is an entrainment burn-up model applicable to the mixing controlled region of turbulent flame propagation. The flame is assumed to propagate spherically from one or two spark plug locations. A heat transfer model that is dependent upon the turbulence level is used to compute the heat loss from the unburned and burned gases.

An experimental and analytical study was conducted to investigate the effects of load control with port throttling on stability and fuel consumption at idle. With port throttling, the pressure in the intake port increases during the valve-closed period due to flow past the throttle. If the pressure in the port recovers to ambient before the valve overlap period, back flow into the intake system from the cylinder is eliminated. This allows increased valve overlap to be used without increasing the residual mass fraction in the cylinder. Results showed that, with high valve overlap and port throttling, idle stability and fuel consumption can be maintained at values associated with low overlap in a conventionally throttled engine. However, implementation of this concept in production is regarded to require precision-fit and balanced port throttles, an external vacuum pump for vacuum systems support, and revision of the PCV system.