Search Results

One-dimensional (1-D) modelling codes are now commonplace in engine simulation programs. Thermodynamic analysis associated with the unsteady gas flow through engine ducting is an important element within the modelling process. This paper reports on a new approach in analysing mass and energy transport through a pipe system using the mesh method. A new system has been developed for monitoring wave energy and gas properties, using a two-dimensional grid to represent the time-mesh boundary domain. This approach has allowed for refinement of the current mesh method by allowing more accurate monitoring of gas properties. The modified method was tested using measured results from a Single-Shot Rig. A CFD analysis was also conducted and compared with the new method. The new method performed very well on the range of pipe geometries tested.

With the legislative demands increasing on recreational vehicles and utility engined applications, the two-stroke engine is facing increasing pressure to meet these requirements. One method of achieving the required reduction is via the introduction of a catalytic converter. The catalytic converter not only has to deal with the characteristically higher CO and HC concentration, but also any oil which is added to lubricate the engine. In a conventional two-stroke engine with a total loss lubrication system, the oil is either scavenged straight out the exhaust port or is entrained, involved in combustion and is later exhausted. This oil can have a significant effect on the performance of the catalyst. To investigate the oiling effect, three catalytic converters were aged using a 400cm3 DI two-stroke engine. A finite level of oil was added to the inlet air of the engine to lubricate the internal workings. The oil flow rate is independent of the engine speed and load.