Search Results

EGR reduces NO emission, but increases smoke and decreases BMEP in diesel engines. This paper describes the relationships between these behaviors and the effect of decreased oxygen with EGR in direct injection, pre-chamber, and turbocharged diesel engines. The results indicate that the reduction of NO depends on decreasing the rate of the incoming oxygen. The increase in smoke and the decrease in BMEP is due to a reduced rate of exhaust oxygen. Also the reduction of NO is due to increased ambient humidity which can be explained by the decreased oxygen in the incoming charge. With these results, it becomes possible to predict the ratio of the reduction of NO emission, the increase in smoke and the decrease in BMEP.

Direct injection diesel engines emit a far more disagreeable exhaust odor at idling than gasoline engines, and with increasing numbers of DI diesel engines in passenger cars, it is important to promote the odor reduction research. High pressure injection in DI diesel engines promotes combustion and decreases particulate matter (PM) emissions, but injection pressures at idling and warm up are limited to 30∼40 MPa considering engine noise and vibration. In this pressure range, a part of the fuel adheres on the relatively cool combustion chamber walls and causes incomplete combustion, producing higher concentration of unburned HC and intermediate combustion components (aldehydes, other oxygenated compounds, etc.) with objectionable exhaust odors. To reduce the exhaust odor, oxidation catalysts are effective, but catalyst activity is poor at idling, when the exhaust gas temperature is low (about 100°C).

This study investigated the effect of high pressure injection and an oxidation catalyst on the exhaust odor of DI diesel engines. At idling an injection pressure of 60∼80 MPa resulted in the minimum exhaust odor, with the least aldehyde and minimum total hydrocarbon (THC). This is because of decreases in fuel adhering to the combustion chamber walls due to the shortest ignition delay at this pressure range. However, above 60 MPa there is no further shortening of the ignition delay and overleaning of the local mixture dominates at injection pressures above 100 MPa, where the exhaust odor increases again. The odor reduction at the optimum injection pressure and injection timing is not significant, and further experiments with an oxidation catalyst were performed. The oxidation catalyst was found less effective to reduce exhaust odor at long idling where the maximum catalyst temperature is only about 120°C.