Search Results

Occurrence of knock in spark ignition (SI) engines is usually suppressed by inhibiting auto-ignition of the fuel-air mixture. A steep increase in pressure by auto-ignition of the local mixture is thought to initiate the pressure oscillation, which results in knock. Therefore, in order to prevent knock, the strength of the pressure oscillation would be decreased by reducing the local heat release of the end gas. In this study, the oxidation reaction rate of the auto-ignition was attempted to be reduced by dilution of the mixture. The effect of mixture dilution on the strength of pressure oscillation, that is knock intensity, was examined using a rapid compression machine (RCM) and a single cylinder SI engine. The test result of compression ignition of homogeneous mixture using RCM showed that increase in dilution ratio could decrease the knock intensity even if the input heat increased and the auto-ignition timing advanced.

This paper presents the effects of a lubricant oil droplet on the start of combustion of a fuel-air mixture. Lubricant oil is thought to be a major source of low-speed pre-ignition in highly boosted spark ignition engines. However, the phenomenon has not yet been fully understood because its unpredictability and the complexity of the mixture in the engine cylinder make analysis difficult. In this study, a single oil droplet in a combustion cylinder was considered as a means of simplifying the phenomenon. The conditions under which a single oil droplet ignites earlier than the fuel-air mixture were investigated. Tests were conducted by using a rapid compression expansion machine. A single oil droplet was introduced into the cylinder through an injector developed for this study. The ignition and the flame propagation were observed through an optical window, using a high-speed video camera.

Furans such as 2-Methylfuran (2-MF) and 2,5-Dimethylfuran (DMF) can be produced from biomass sugars and offer superior properties for use in SI engines. This paper describes the study of the auto-ignition characteristics of furans and other biofuels using a rapid compression machine. Blending with PRF90 and RG, the auto-ignition suppression of 2-MF was almost equal to that of ethanol and larger than toluene, although the auto-ignition delay of pure 2-MF was shorter than that of ethanol and toluene. This was because 2-MF suppresses the cool flame reaction. Knock evaluation using a single-cylinder research engine also indicated that the addition of 2-MF improved the anti-knock properties as well as ethanol.

A multi-component fuel vaporization model is developed for numerical analysis of specific fuel component behaviors in port-fuel-injection(PFI) gasoline engines. In order to specify the differences of in-cylinder fuel distribution among its components, three-dimensional calculations of intake flow, spray and vapor motion of each component are performed with respect to engine wall temperature and the distillation characteristics of the fuel. Simultaneous measurements of in-cylinder behaviors of different volatility components in the fuel are also carried out using a laser-induced fluorescence (LIF) technique to validate the calculation results. In both measurements and calculations, the same fuels are used, which are composed of seven or eight components to simulate the distillation characteristics of two kinds of gasoline. The in-cylinder vapor amount of high and low volatility components is compared between the calculations and the experiments.