Refine Your Search

Search Results

Viewing 1 to 3 of 3
Technical Paper

Emission Rates and Elemental Composition of Particles Collected from 1995 Ford Vehicles Using the Urban Dynamometer Driving Schedule, the Highway Fuel Economy Test, and the USO6 Driving Cycle

1997-10-01
972914
Within the last six-eight years many papers have reported an association between increased levels of particulate (aerodynamic size less than 10 microns in diameter) air pollution and increased daily death rates and illness in major cities in the US, Europe, and South America. There is a need to better characterize the emission rates and chemical composition of particles emitted from vehicles equipped with the latest emission reduction technology. Particle-mass emission rates were measured for four 1995 Ford vehicles driven over three different driving cycles: the Urban Dynamometer Driving Schedule (UDDS), the Highway Fuel Economy Test (HFET), and the USO6 driving cycle. The average particle-mass emission rates were less than 10 mg/mi for any of the driving cycles. The particle-mass emission rate was least for the HFET and about equal for the UDDS and the USO6 cycles.
Technical Paper

Emissions of Toxicologically Relevant Compounds Using Fischer-Tropsch Diesel Fuel and Aftertreatment at a Low NOx, Low Power Engine Condition

2005-10-24
2005-01-3764
Previously we reported (SAE Paper 2005-01-0475) that emissions of toxicologically relevant compounds from an engine operating at low NOx conditions using Fischer-Tropsch fuel (FT100) were lower than those emissions from the engine using an ultra-low sulfur (15 PPM sulfur) diesel fuel (BP15). Those tests were performed at two operating modes: Mode 6 (4.2 bar BMEP, 2300 RPM) and Mode 11 (2.62 bar BMEP, 1500 RPM). We wanted to evaluate the effect on emissions of operating the engine at low power (near idle) in conjunction with the low NOx strategy. Specifically, we report on emissions of total hydrocarbon (HC), carbon monoxide (CO), NOx, particulates (PM), formaldehyde, acetaldehyde, benzene, 1,3-butadiene, gas phase polyaromatic hydrocarbons (PAH's) and particle phase PAH's from a DaimlerChrysler OM611 CIDI engine using a low NOx engine operating strategy at Mode 22 (1.0 bar BMEP and 1500 RPM).
Technical Paper

Emissions of Toxicologically Relevant Compounds Using Dibutyl Maleate and Tripropylene Glycol Monomethyl Ether Diesel Fuel Additives to Lower NOx Emissions

2005-04-11
2005-01-0475
A previous paper reported (SAE Paper 2002-01-2884) that it was possible to decrease mode-weighted NOx emissions compared to the OEM calibration with corresponding increases in particulate matter (PM) emissions. These PM emission increases were partially overcome with the use of oxygenated diesel fuel additives. We wanted to know if compounds of toxicological concern were emitted more or less using oxygenated diesel fuel additives that were used in conjunction with a modified engine operating strategy to lower engine-out NOx emissions. Emissions of toxicologically relevant compounds from fuels containing triproplyene glycol monomethyl ether and dibutyl maleate were the same or lower compared to a low sulfur fuel (15 ppm sulfur) even under engine operating conditions designed to lower engine-out NOx emissions.
X