Search Results

Drag reducing agents (DRAs) are extensively used to increase the capacity of pipelines to transport crude oils and finished products. The amount of DRA that can be used in gasoline is limited by the tendency of the high molecular weight DRAs to form engine deposits. The use of deposit control additives (DCAs) could help to mitigate this effect, enabling increased DRA treatment rates and improved pipeline capacity. A study has been undertaken to investigate the engine test response of these additives, and has suggested that higher DRA treat rates may be possible when accompanied by a deposit control additive to address increased intake valve deposits. Conversely, the effect on combustion chamber deposits is not clear and further studies would be required. Other engine related aspects such as intake valve deposit stick have also been investigated and under the conditions tested do not appear to be adversely affected by either the DRA or the deposit control additive.

An arrangement of port - injected, stratified-charge, 4 - valve SI engine is proposed, in which fuel is injected in a thin column from an injector which is angled so that the fuel is deflected by one of the inlet valves onto the combustion chamber surface, at a position close to the central spark plug. The injection takes place towards the end of the induction stroke, and the injector is mounted to the side of one of the intake ports. The second intake port is deactivated at part load to establish an axial swirling motion to stabilise the fuel evaporating from the warm combustion chamber surface. Testing has been performed on a single - cylinder research engine to assess the extent of the stratification by measuring pre - flame hydrocarbon concentrations at various positions around the combustion chamber.

With Euro III emissions standards requiring a 50% reduction in current diesel car emissions from January 1st 2000, there is a need to improve fuel consumption and thus reduce exhaust emissions. One of the ways this is being addressed is by the introduction of lower viscosity crankcase oils and by the use of friction modifiers within these oils. The resulting reduced engine friction contributes to improved fuel economy and should also aid engine cold start ability. To investigate the cold start abilities of different crankcase oils, a matrix consisting of six different oil formulations was tested at -20°C, - 25°C and -30°C in a two litre four cylinder diesel engine. The tests were conducted using a dynamometer, with the engine being driven by the dynamometer at nominal cranking speed for 30 seconds and then increased to cold idle speed for a further 30 seconds.