Search Results

Particle number emissions from an off-road diesel engine without exhaust after-treatment were studied by using five different heavy-duty lubricating oils in the engine. The study extends understanding on how the properties of lubricating oil affect the nanoparticle emissions from an off-road diesel engine. The lubricants were selected among the performance classes of the European Automobile Manufacturers Association, at least one lubricant from each category intended for heavy-duty diesel engines. Particle size distributions were measured by the means of an engine exhaust particle sizer (EEPS), but soot emissions, gaseous emissions and the basic engine performance were also determined. During the non-road steady state cycle, the most of the differences were detected at the particle size range of 6-15 nm. In most cases, the lowest particle quantities were emitted when the highest performance category lubricant was used.

The effect of SCR on nanoparticle emissions has been a subject for some recent diesel particle emission related studies. In this study, the effect of after-treatment (DOC and SCR) on particle emissions was studied with a heavy-duty off-road diesel engine (emission level stage 3b with an SCR). A special “transient cold test cycle” (TCTC) was designed to describe the SCR system operation at low exhaust gas temperatures. The particle instrumentation made it possible to measure on-line the particle number concentration, particle size distribution and chemical composition of particles. The largest particle number concentrations were measured after the exhaust manifold. The exhaust after-treatment was observed to reduce the total particle number concentration by 82.5% with the DOC and 95.7% with the DOC+SCR.

Number concentration of particles emitted by combustion engines has recently attracted attention, due to the fact that particles of the size range found in tail pipe emissions are suspected of being hazardous to human health. This paper describes the application of an Electrical Low Pressure Impactor (ELPI) to the measurement of number concentrations of diesel exhaust particles. The size distribution of particles as fine as 30 nm is determined using the aerodynamic diameter as the characteristic dimension. Results were obtained on both the engine and chassis dynamometer, in real-time, for steady state and transient tests. Swedish Environmental Class 1 diesel fuel was used, having a sulfur content of less than 10 ppm wt. A scheme for the calculation of particle losses in the sampling system was developed, showing high penetration of particles under the conditions examined.

During the past few decades the exhaust emissions of diesel engines have significantly decreased due to efficient emissions regulation. Compared to the situation in the 1990s, the nitrogen oxide (NOx) and particulate matter (PM) emissions, the main challenges for diesel engines, are now reduced 80-95 % in many industrialized countries. To meet the demanding requirements, engine technologies have been updated and improved step by step. These improvements have also kept Specific Fuel Consumption (SFC) figures at a low level or they have even improved. The latter issue is of great significance for consumers (cost) and also for the environment (CO2). Nowadays many diesel engine fuel injection strategies rely on the use of exhaust after-treatment systems. Efficient and clean combustion is obtained by utilizing high injection pressure and advanced injection timing.