Search Results

In this study, tailpipe-sampling was used to sample the exhaust aerosol of a Stage IV tractor equipped with Diesel Oxidation Catalyst (DOC) and Selective Catalytic Reduction (SCR) aftertreatment systems. The particle emissions were characterized in terms of number concentration (particle size of > 2.5 nm), mass concentration (particle size of 6-612 nm) BC mass concentration and chemical composition (particle size of > 30 nm). The measurements were conducted on-road by setting a mobile laboratory on a trailer and pulling it with the tractor. In addition to driving, heavy-lift work cycles were tested, where separate lifts of a 1000 kg weight were conducted with the front fork of the tractor with two minutes of idling between consecutive lifts. Both a Porous Tube Diluter (PTD) with ambient temperature dilution air as well as an ejector diluter with hot dilution air were used to sample the exhaust aerosol.

The aim of this paper is to analyze the quantitative impact of fuel sulfur content on particulate oxidation catalyst (POC) functionality, focusing on soot emission reduction and the ability to regenerate. Studies were conducted on fuels containing three different levels of sulfur, covering the range of 6 to 340 parts per million, for a light-duty application. The data presented in this paper provide further insights into the specific issues associated with usage of a POC with fuels of higher sulfur content. A 48-hour loading phase was performed for each fuel, during which filter smoke number, temperature and back-pressure were all observed to vary depending on the fuel sulfur level. The Fuel Sulfur Content (FSC) affected also soot particle size distributions (particle number and size) so that with FSC 6 ppm the soot particle concentration was lower than with FSC 65 and 340, both upstream and downstream of the POC.

The effect of a novel particle oxidation catalyst (POC®) on diesel particle emissions is studied in heavy duty and light duty applications. Regulated particulate matter (PM) emission measurement is followed by analyzing either soluble organic fraction (SOF) or volatile organic (VOF) fraction. In addition, in heavy duty diesel application, size distributions are measured. Results show that PM reductions as high as 48-79% can be achieved when using POC in combination with a conventional diesel oxidation catalyst (DOC). As expected, the volatile fraction of the PM was very effectively reduced, but also the non-volatile fraction (i.e. soot) was reduced. In tested steady state driving modes soot reduction was found to be 31-55%.

Under on-road driving conditions, the engine load and speed and the cooling effect of ambient air may affect the functioning of exhaust aftertreatment devices. In this paper, we studied the effects of these parameters on the functioning of the combination of a Diesel Oxidation Catalyst and a Particle Oxidation Catalyst (DOC+POC). In the engine tests, the engine load and speed were observed to affect the nonvolatile particle reduction efficiency curve of the DOC+POC; while the nonvolatile core particle (Dp ≺ 15 nm) reduction was high (97-99%) in all the engine test modes, the reduction of soot varied from 57% at low load to 70% at high load. Because the change in engine load and speed affected both the exhaust temperature and flow velocity, the effects of these parameters were measured separately in an aerosol laboratory.