Search Results

This paper describes experiments to determine the effect on exhaust emissions of starting on compressed natural gas (CNG) and then switching to gasoline once the catalyst reaches operating temperature. Carbon monoxide, oxides of nitrogen, and detailed exhaust hydrocarbon speciation data were obtained for dedicated CNG, then unleaded gasoline, and finally CNG start -gasoline run using the Federal Test Procedure at 24°C and at -7°C. The result was a reduction in emissions from the gasoline baseline, especially at -7°C. It was estimated that CNG start - gasoline run resulted in a 71 percent reduction in potential ozone formation per mile.

This paper describes experiments conducted to determine the regulated emissions, ozone-forming potentials, specific reactivities, and reactivity adjustment factors for eight butane and propane alternative fuel blends run on a light-duty vehicle, emission certified to be a California transitional low emission vehicle (TLEV) and converted to operate on liquefied petroleum gas (LPG). Duplicate EPA FTP emission tests were conducted with each fuel. Hydrocarbon speciation was utilized to determine reactivity-adjusted non-methane organic gases (NMOG) emissions for one test on each fuel. Results showed that all eight fuels could allow the converted vehicle to pass California ultra-low emission vehicle (ULEV) NMOG and oxides of nitrogen (NOx) standards. Six of the eight fuels could allow the vehicle to pass ULEV carbon monoxide (CO) standards. BUTANE has been an important gasoline blending component for many years.

The influence of fuel composition on exhaust emissions from four 1982 model light-duty diesel vehicles was studied on the FTP cycle and at two steady-state conditions, but only the FTP results are presented and discussed in this paper. Nine test fuels were blended specifically for the program, with intentional variation in aromatic content, 90% boiling point, and 10% boiling point. Limited data were also acquired with injection timing at advanced and retarded settings, in addition to the main body of data taken with the engines adjusted to recommended timing. A comparatively small effort was also made to evaluate a tenth fuel consisting of a blend of two of the original nine fuels. Of the fuel characteristics varied intentionally, aromatic content generally had the greatest effect on most emissions of major interest (hydrocarbons, oxides of nitrogen, particulate, soluble organic fraction, polynuclear aromatic hydrocarbons, and mutagenicity of extract by Ames bioassay).