Search Results

Homogeneous Charge Compression Ignition (HCCI) engines offer high fuel efficiency and some emissions benefits. However, it is difficult to control and stabilize combustion over a sufficient operating range because the critical compression ratio and intake temperature at which HCCI combustion can be achieved varies with operating conditions such as speed and load as well as with fuel octane number. Replacing part of the base fuel with reformer gas, (which can be produced from the base hydrocarbon fuel), alters HCCI combustion characteristics in varying ways depending on the replacement fraction and the base fuel auto-ignition characteristics. Injecting a blend of reformer gas and base fuel offers a potential HCCI combustion control mechanism because fuel injection quantities and ratios can be altered on a cycle-by-cycle basis.

This paper describes use of reformer gas (RG) to alter and control combustion in a CNG-fueled HCCI engine. Experimental work used a mixture of simulated RG (75% H2 and 25% CO) to supplement base CNG fueling in a CFR engine upgraded to achieve high compression ratios. RG was used to improve the engine's operating performance and to control combustion onset in experiments conducted at three different compression ratios. A combination of high compression ratio (18.5) and high intake temperature (140°C) was observed to be appropriate to run the CNG-fueled CFR engine in HCCI mode. RG replacement of CNG altered combustion characteristics and expanded the operating range on the lean side. Use of RG decreased knock severity and reduced NOx emission. At constant relative air/fuel ratio (λ) it advanced combustion timing, moving the maximum cylinder pressure earlier in the cycle and increasing maximum pressure.

High speed Schlieren video and pressure trace analyses were used to study the turbulence effects on burning velocities in a constant volume combustion chamber. Propane-air and methane-air mixtures of equivalence ratios between 0.75 and 0.96 were ignited at 101 kPa and 296 K. Schlieren images of flame growth were recorded on video at 2000 frames per second while combustion chamber pressure was simultaneously recorded. Turbulence at ignition was up to 7 m/s intensity with 2 mm or 8 mm integral scale, produced by pulling a perforated plate across the chamber prior to ignition. In the analysis, the turbulence parameters during combustion were adjusted for the effect of decay and rapid distortion in a closed chamber. Results of both video and pressure trace analyses show a linear relationship between turbulent burning velocity and turbulence intensity as expected.

The different roles played by small and large eddies in engine combustion were studied. Experiments compared natural gas combustion in a converted, single cylinder Volvo TD 102 engine and in a 125 mm cubical cell. Turbulence is used to enhance flame growth, ideally giving better efficiency and reduced cyclic variation. Both engine and test cell results showed that flame growth rate correlated best with the level of high frequency, small eddy turbulence. The more effective, small eddy turbulence also tended to lower cyclic variations. Large scales and bulk flows convected the flame relative to cool surfaces and were most important to the initial flame kernel.