Search Results

In this paper the behavior of the three-way catalyst equipping a 2-liter car is fully analyzed considering exhaust gas and ceramic temperatures trends ( and of related engine parameters) in on-road operations of the car under different traffic conditions. These are classified by means of driving cycles clusters determined by multivariate statistical analysis of car speed and gear usage real profiles, detected on-road by the same car in designed experimental plans. Instantaneous fuel consumption and signals of a linear oxygen sensor, placed up-stream catalyst, have been analyzed to better characterize engine and catalyst performance. Emissions are measured in laboratory performing the most statistically representative driving cycles with car on the dynamometer chassis. The effect of traffic conditions on catalyst behavior and exhaust emissions is analyzed through the study of series of consecutive driving cycles.

The fossil fuel consumption and the related environmental impact are important issues for the world research community: hydrogen seems to be a good alternative to fossil fuels provided that it is produced from renewable energy sources. The aim of the present work is the comparison between natural gas and a hydrogen-natural gas blend (HCNG in the following) in terms of exhaust emissions and fuel consumption. A passenger car has been tested on a chassis dynamometer according to the European emission regulations, without any change on engine calibration (i.e. spark advance). The HCNG blend used during the test has a 12% vol. of hydrogen content. CO emissions showed a reduction of about 19% when HCNG blend is used, while HC emissions remained constant. A 70% increase was observed for NOx emissions with HCNG. A 3% reduction for CO2 emission was observed using HCNG because of the lower carbon content in the blend and the reduced fuel consumption on a mass basis.

The effect of different fuel parameters on emissions is difficult to understand, the response depending upon different engine technologies. In addition the isolation of some of the fuel variables is often very hard. The present paper discusses the main results obtained testing a matrix of 14 fuels designed for obtain large variations of cetane number, sulphur and aromatic contents of Diesel oil. The aromatic structure of fuels and its effect on particulate emissions was also investigated. A linear regression analysis was performed in order to isolate the main controlling factors on particulate emissions. Finally the influence of aromatic contents of fuel on unregulated emissions was also assessed.

Cetane number, sulphur content and aromatic structure of Automotive Diesel Oil (ADO) were changed to assess their influence on emissions of light duty direct injection Diesel engine. The detailed chemical analysis of particulate soluble fraction allows to quantify the P.A.Hs emission. In addition also the aldehydes and volatile organic compounds were measured in the gaseous phase. The sulphur content of the fuel and its aromatic structure strongly influence particulate emission. The insoluble fraction of the particulate rises with an increase of the high sulphur content ADOs with about the same back end volatility. Unburned P.A.Hs control P.A.Hs emission at the part loads typical of normalized schedules for emission testing of light duty vehicles in Europe. Finally the level of emissions of benzene and 1-3 butadiene is comparable to the total P.A.Hs emission.

Unregulated emissions of polycyclic aromatic hydrocarbons (PAHs), carbonylic compounds, benzene and particulate matter (PM) were quantified in exhausts of a vehicle fleet representative of in use gasoline cars. Emission factors were obtained during both cold and hot start driving cycles (from urban to motorway driving conditions). Carbonylic compounds were sampled by DNPH cartridges and analyzed by HPLC. Benzene and other light hydrocarbons were collected in bags and then analyzed by GC-FID. PAHs were trapped in XAD-2 cartridges and then analyzed by GC-MS. PM was sampled by using the gravimetric procedure required for diesel cars. The effect of technology is significant with respect to regulated and unregulated emissions but different emissive behavior was found by varying the driving cycles. Cold start has a major influence on hydrocarbon emissions (included unregulated ones). This experimental work was carried out within the framework of the EU Artemis project.

A novel model has been developed for the analysis and the evaluation of average vehicle emissions in a real driving cycle (emission factors) from data in an emission database. The model assumes that emission variation can be explained by parameters determined from dynamic vehicle equation and by the frequency of acceleration events at different speeds. Because the number of resulting X-variables is large, and variables are correlated, a regression method based on principal components, the Partial Least Squares (PLS) method actually, has been adopted. In this paper, model potentiality is illustrated by an application to a case study taken from the database built within the UE V Framework Project ARTEMIS. Data are relative to tests performed under hot conditions with a sample of EURO III 1.4-2.0 l gasoline passenger cars. A set of real driving cycles was utilized as representative of urban, rural and motorway operating conditions detected in different European countries.

The 1997 Kyoto International Conference Protocol committed industrialized countries to reduce their global emissions of greenhouse gases within the period 2008 2012 by at least 5% with respect to 1990. In view of this and following the European Community directives, the Italian government approved a three-year pilot project to promote the experimental employment of biodiesel. The methyl esters of vegetable oils, known as biodiesel are receiving increasing interest because of their low environmental impact and their potential as an alternative fuel for diesel engines as they would not require any significant modification of existing engines. Consequently, an experimental research program has been developed to evaluate performance and emissions of a Diesel engine fueled with a methyl ester derived from rape seed (Rapeseed Methyl Ester or RME) by changing the composition of the diesel fuel-RME mixture. This program aims to analyze the performance and emissions of a turbocharged D.I.

The attention on emissions of two-wheelers has been poor in the past, but today in countries with a large two-wheeler population it gives a significant contribution to aggregate emissions. In this paper the results obtained on a fleet composed by 22 two-stroke motorcycles (including mopeds) are presented. Sixteen in-use mopeds and six 125 cm3 motorcycles have been tested over ECE 47 and ECE 40 driving cycles respectively. Regulated emissions (CO, HC, NOx), carbon dioxide, benzene and fuel consumption have been evaluated by fueling motorcycles with two different gasoline formulations. One gasoline was a commercial Italian leaded gasoline with 1% benzene content; the other was a lower benzene and aromatics content gasoline. Benzene emissions decreased according to benzene content of gasoline.