Search Results

The aim of this paper is to show that the gains, technical and/or economical, from the use of ethanol as fuel in agricultural aviation may be even greater if the aircraft engine is specially designed for that purpose. A specific design is also necessary if it is intended to achieve a truly "green" engine, neutral regarding carbon emissions. Using available technologies, computational tools, development methods and project management methods (Reference Model for Agricultural Machinery Development Process (RM-AMDP), the engine can be fully developed to be used specifically as an agricultural aircraft propellant operating with ethanol. In Brazil, the current fleet of agricultural airplanes has around 1500 aircrafts and almost all operating with AvGas (Aviation Gasoline). There is already in Brazil a "green" airplane, manufactured by Neiva, a subsidiary of the aircraft manufacturer Embraer. This model uses a conversion kit on the original engine to use ethanol as fuel.

Ethanol with high levels of hydration is a low cost fuel that offers the potential to replace fossil fuels and contribute to lower carbon dioxide (CO2) emissions. However, it presents several ignition challenges depending on the hydration level and ambient temperature. Advanced combustion concepts such as homogeneous charge compression ignition (HCCI) have shown to be very tolerant to the water content in the fuel due to their non-flame propagating nature. Moreover, HCCI tends to increase engine efficiency while reducing oxides of nitrogen (NOx) emissions. In this sense, the present research demonstrates the operation of a 3-cylinder power generator engine in which two cylinders operate on conventional diesel combustion (CDC) and provide recycled exhaust gas (EGR) for the last cylinder running on wet ethanol HCCI combustion. At low engine loads the cylinders operating on CDC provide high oxygen content EGR for the dedicated HCCI cylinder.

The possibility to vary compression ratio offers a new degree of freedom that may enable so far not exploited benefits for the combustion process especially for highly boosted spark ignited engines. Numerous approaches to enable a variable compression ratio (VCR) have been tried and tested in the past. Nevertheless, none of these systems reached series production because of several reasons, ranging from too much complexity and moveable parts to deep modification required on existing engine architectures and manufacturing lines. Instead, the approach of a variable length conrod (VCR conrod) could be the solution for integration in almost any type of engine with minor modifications. It is then considered by several OEMs as a promising candidate for midterm series production. This paper shows, firstly, a discussion of the benefits of a variable compression ratio system.

The prediction of ignition delay times is very useful during the development phase of internal combustion engines. When it comes to biofuels such as ethanol and its blends with gasoline, its importance is enhanced, especially when it comes to flex-fuel engines and the need to address current and future emissions legislations and efficiency goals. The ignition delay time measured as the angular difference between the spark discharge time, as commanded by the ECU and a relevant fraction of fuel mass burned (usually, 2, 5 or 10%). Experimental tests were performed on a downsized state-of-the-art internal combustion engine. Engine speed of 2500 rpm, with load of 6 and 13 bar IMEP were set for investigation. Stoichiometric operation and MBT or knock-limited spark timings were used, while valve overlap was varied, in order to address the effects of scavenging and residuals on ignition delay times.

This study evaluates the performance of an ethanol fueled spark ignited engine running with high levels of hydration. Ethanol is a renewable fuel and has been considered a promising alternative to counteract global warming and to reduce pollutant emissions. Its use is well established in ICE as the main fuel or blended with gasoline. However, due to its lower calorific value, it shows increased fuel consumption when compared to gasoline, rendering its use sometimes less attractive. The energy demand to produce ethanol, especially at the distillation phase, increases exponentially as the concentration of ethanol-in-water goes from 80% onwards. Thus, mixtures with less than 80% of ethanol-in-water would reduce the energy consumption during production, yielding a less expensive fuel. In previous studies, to evaluate the feasibility of wet ethanol as a fuel for spark-ignited engines, results have shown that it was possible to use mixtures of up to 40% of water-in-ethanol.