Search Results

Downsizing is widely considered one of the main path to reduce the fuel consumption of spark ignition internal combustion engines. As known, despite the reduced size, the required torque and power targets can be attained thanks to an adequate boost level provided by a turbocharger. However, some drawbacks usually arise when the engine operates at full load and low speeds. In fact, in the above conditions, the boost pressure and the engine performance is limited since the compressor experiences close-to-surge operation. This occurrence is even greater in case of extremely downsized engines with a reduced number of cylinders and a small intake circuit volume, where the compressor works under strongly unsteady flow conditions and its instantaneous operating point most likely overcomes the steady surge margin. In the paper, both experimental and numerical approaches are followed to describe the unsteady behavior of a small in-series turbocharger compressor.

Turbocharging technique will play a fundamental role in the near future not only to improve automotive engine performance, but also to reduce fuel consumption and exhaust emissions both in Spark Ignition and diesel automotive applications. To achieve excellent engine performance for road application, it is necessary to overcome some typical turbocharging drawbacks i.e., low end torque level and transient response. Experimental studies, developed on dedicated test facilities, can supply a lot of information to optimize the engine-turbocharger matching, especially if tests can be extended to the typical engine operating conditions (unsteady flow). Different numerical procedures have been developed at the University of Naples to predict automotive turbocharger compressor performance both under steady and unsteady flow conditions. A classical 1D approach, based on the employment of compressor characteristic maps, was firstly followed.

The flow in turbocharger compressors and turbines for automotive engine application is highly unsteady in nature, as it responds to the intake and exhaust manifolds of the internal combustion engine. The optimization of the turbocharger system is therefore a very difficult task, since only steady flow maps are generally provided by turbocharger manufacturer. For several years a specialized components test facility operates at the University of Genoa, particularly suitable to test turbochargers under steady and unsteady flow conditions. The test bench has been continuously upgraded in order to study components under pulsating flow condition by using different layout configurations. A recent set-up makes it possible to study turbocharger compressor under unsteady flow condition by using a rotating valve pulse generator system. Measurements of pressure signals downstream the compressor, instantaneous mass flow rate and turbocharger rotational speed are performed.

To downsize a spark ignited (SI) internal combustion engine (ICE), keeping suitable power levels, the application of turbocharging is mandatory. The possibility to couple an electric drive to the turbocharger (electric turbo compound, ETC) can be considered, as demonstrated by a number of studies and the current application in the F1 Championship, since it allows to extend the boost region to the lowest ICE rotational speeds and to reduce the turbo lag. As well, some recovery of the exhaust gas residual energy to produce electrical energy is possible. The present paper shows the first numerical results of a research program under way in collaboration between the Universities of Pisa and Genoa. The study is focused on the evaluation of the benefits resulting from the application of ETC to a twin-cylinder small SI engine (900 cm3).