Search Results

A test protocol, allowing for the evaluation of diesel particulate filters of different materials and of different sizes, located at various distances from the engine was developed. A total of 13 filter configurations were tested on a Euro I naturally aspirated diesel light duty truck with a fully passive trap system, utilizing only cerium-based additive in the fuel. It was proved that regeneration under constant urban driving conditions was always possible, at an exhaust gas temperature at the trap inlet in the range of 250 - 350°C. On a gravimetric basis, the efficiency of the traps tested concerning PM was in the order of 45 - 80% over the NEDC, depending on trap material and location along the exhaust pipe and reflecting the specific composition of the PM generated by the vehicle. No major effect on gaseous emissions (HC, NOx and CO) was observed.

A light duty truck Renault Trafic with a naturally aspirated 2.5 l diesel engine was equipped with metal particulate filters of different sizes, installed at different positions along the exhaust pipe of the vehicle. The filters were operated on diesel fuel doped with a cerium based additive at concentration of 100 ppm in the fuel. Tests were carried out on chassis dynamometer using continuous repetition of the urban part of the European Driving Cycle as a « worst case » approach. Comparisons are made between the different sizes and positioning as regards both back-pressure build up and catalytic regeneration behavior. The results show that filter regeneration was always possible at continuous low speed driving, at relatively high filter back-pressure levels (i.e. high particulate accumulation in the filter), with an effect on fuel consumption.

A light duty truck Renault Trafic with a naturally aspirated 2.5 l engine was equipped with ceramic DPFs of different sizes, installed at different positions along the exhaust line of the vehicle. The filters were operated on diesel fuel doped with a cerium based additive at concentration of 100 ppm in the fuel. Tests were carried out on chassis dynamometer using the urban part of the new European driving cycle and the full new European Driving cycle. Comparisons are made between the different sizes and positioning as regards both back-pressure build-up and catalytic regeneration behavior. The results show that filter regeneration was always possible at continuous low speed driving, at relatively high filter back-pressure levels (i.e. high particulate accumulation in the filter), with an effect on fuel consumption.