Search Results

The paper discusses the general lubrication problems associated with operation of high-output aircraft engines. Since the paper is concerned with two types of aircraft engines, namely, turbine and reciprocating, a natural division into two parts is made. Part I deals with the problems of turbine engines, and part II deals with the problems of reciprocating engines. In part I it is indicated that the choice of a lubricant is very difficult for the turbine engine particularly, because of the wide temperature range (from -67°F to approximately 400° F). Two solutions to the problem of proper choice of a lubricant are discussed, namely (1) the use of supplemental lubricants, and (2) the use of additive lubricants. Data are presented on supplemental lubricants including the various oxides of iron, molybdenum disulfide and graphite.

Wear studies were made to show the effects on performance of temperature, type of mating materials, and minor composition changes in typical carbon seal materials. Most data were obtained at a sliding velocity of 10,000 feet per minute, a load of 1000 grams on a 3/16 inch radius specimen and with temperatures to 700 F. Wear of carbon materials increased rapidly with higher temperatures. The effect of temperature on wear was reduced by use of chromium plate as the mating surface rather than stainless steel or tool steel. In general, impregnations of carbon had little effect on wear compared with effect of the mating material.

Research information on solid lubricants has been compiled for consideration in the possible use of such materials in aircraft electrical equipment. Solid lubricants are capable of lubricating at the maximum temperatures (600° F) for aircraft electrical equipment. Many solids that adhere well to metals may be useful lubricants; those with layer-lattice structure usually give low friction. Solid lubricants are most commonly used as bonded films but the use of fluid carriers and surface reaction products have considerable merit.

This paper summarizes the results and findings of a program to design, develop, and evaluate actuator rod seals for use in advanced aircraft high-temperature hydraulic systems. The rod seals are intended to function efficiently and reliably for 3000 hr in the temperature range of -40-500 F. Preliminary studies of various material and design combinations showed that a polyimide low-pressure second-stage V-seal in a two-stage configuration had the greatest potential in long-term duty cycle testing in a simulated actuator test system. Modifications of this seal that provided for improved fatigue life and more efficient loading met the test objectives of 20 X 106 short-stroke cycles of operation at 500 F. Severity of this testing was equivalent to 3000 hr of duty cycle operation. The validity of design techniques used to achieve performance goals was shown.