Search Results

State of the art technologies of 2 and 4 stroke engines have to fulfill severe future exhaust emission regulations, with special focus on the aspects of rising performance and low cost manufacturing, leading to an important challenge for the future. In special fields of applications (e.g. mopeds, hand held or off-road equipment) mainly engines with simple mixture preparation systems, partially without exhaust gas after treatment are used. The comparison of 2 and 4 stroke concepts equipped with different exhaust gas after treatment systems provides a decision support for applications in a broad field of small capacity engine classes.

The future exhaust emission legislation limits and the procedures for running the test cycles will have an important influence on future range extender concepts. Due to the special steady state operation strategy of the range extender engines, it is possible to create a simple methodology for comparing engine test bench emissions with the emission limits of exhaust gas legislations. Therefore the energy demand of a predefined vehicle was simulated with PHEM, a longitudinal dynamic simulation tool. According to that, the influence of different exhaust gas after treatment systems and preheating options on the tolerated raw emission concentration will be analyzed. With this information, a few chosen range extender engine concepts will be compared concerning their suitability for future exhaust emission legislations. The selection of the range extender concepts was carried out with the methotology of a value benefit analysis.

One possible path to reduce the CO2 emissions of hand-held power tools are fuels with different amount of renewable content. Within this paper test bench measurements on a small two-stroke engine were carried out. We are trying to reduce CO2 emissions by using fuels which absorbed CO2 from the air during its lifetime or production, so called Zero CO2 fuels The focus was set on the investigation of combustion behaviour, performance and emissions of Zero CO2 fuels in comparison to commonly available fuels. For our measurements we chose a 46 cc serial engine, which was slightly modified for scientific research. This paper shows findings on effects of renewable fuels on engine characteristics. Additionally, the chemical properties of each fuel were investigated in order to form a comprehensive picture, together with the performed dyno measurements.

Future emission regulations for two wheeler vehicles driven by small capacity engines will include the cold start characteristics and the durability behavior. [1] Based on the European homologation cycle ECE R47 and an additional cold start test cycle, a number of scooters driven by 50cc engine concepts in combination with different exhaust gas after treatment strategies have been analyzed and evaluated. The test series have been performed with the help of a CVS measurement system according the European homologation instruction and in addition with the help of an online emission recorder measurement.

Future exhaust emission targets and increasing customer demands call for the implementation of enhanced engine technologies, as well known from automotive applications, into small capacity engine categories. Especially the applied engineering solutions in the market of motor vehicles driven by engines up to 50 cm3 displacement have been significantly changed in the last years. Beside low cost technologies (air cooled two stroke or four stroke engines with carburetor), enhanced mixture preparation and exhaust gas after treatment systems come to use. Highly technological two stroke engines are equipped with direct fuel injection systems in combination with efficient exhaust gas after treatment methods; in four stroke engine applications intake port fuel injection systems in combination with oxidation catalysts or 3-way catalytic conversion are established on the market.

The new generation of metallic substrates for catalytic converters used in the two and three wheeler industry is capable of improving conversion behavior even with smaller catalyst size. The lowering of production costs due to less use of precious metal is possible. This novel technological application in motorcycle vehicle class improves exhaust emission performance and introduces a new competitive product on the market. Specially developed foil structures, which transform a laminar exhaust gas flow to a turbulent one, significantly improve exhaust gas mixing behavior in the catalyst. This publication is dealing with the analysis of different metallic substrate foil structures for the catalyst conversion performance and the light-off characteristics for the leading state of the art four stroke 150 cm3 motorcycle technology developed for the Asian market.