Search Results

A direct injection stratified charge engine using New Mixture Formation Technology (OSKA) has been developed. Experiments on a single cylinder engine, with methanol and gasoline fuels showed the following results: 1) With methanol, the maximum IMEP was 1.3 MPa and the best indicated thermal efficiency was 46 %. 2) With gasoline, the maximum IMEP was 1.16 MPa and the best indicated thermal efficiency was 43 %. Analysis of the cylinder pressure diagram showed the following results: 1) High indicated thermal efficiency was observed by low time loss. 2) A relatively short combustion duration was observed even if the engine was operated with an overall lean fuel-air mixture in the part-load condition. This fact suggests that a stratified charge was attained. 3) From observation of the heat release rate,it will be predicted that combustion is characterized by flame propagation.

Ethanol is a promising alternative to fossil fuels because it can be produced from biomass resources that are renewable. Due to the amount of production, however, the usage would be limited to blends with other conventional fuels. Ethanol-fuel blends are azeotropic and have unique vaporization characteristics different from blends composed of aliphatic hydrocarbons, so that the present study developed a numerical scheme which takes into account the vapor-liquid equilibrium of azeotrope in order to update the author's original version of the multi-component fuel CFD model and to evaluate the effect of mixing ethanol into gasoline on the evaporation process. The numerical simulation was implemented for evaporating sprays of ethanol-n-heptane blends, which are injected through a single hole nozzle. In addition to the vapor-liquid equilibrium, the effect of the latent heat of vaporization was investigated.

A new scavenging method for two-stroke cycle engines - Multi-Layer Stratified Scavenging (MULS) - has been developed. The MULS method is achieved by separating the mixture generated by the carburetor into a rich mixture and a lean mixture between the inlet manifold and the scavenging ports, and by finely controlling the scavenging flows. With the MULS method the thermal efficiency and HC emissions of two-stroke cycle gasoline engines are considerably improved without sacrificing the brake specific power output and mechanical simplicity.

The new idea incorporates an impinging part in the central piston cavity. A relatively low injection pressure, lower than that of a conventional IDI Diesel engine, and a single hole fuel nozzle are used. The fuel spray is injected against the impinging part, spreads and forms a fuel-air mixture. Since a comparatively rich fuel-air mixture always stays around the impinging part and ignition is accomplished near the center of the mixture, steady, instantaneous and high-speed combustion is possible. As the fuel-air mixture is formed mostly in the cavity, there is little fuel in the squish area. Therefore, it is possible to prevent end-gas knocking, and in spite of the use of spark ignition, to employ a higher compression ratio than that of the conventional premixed SI engine. Experiments with a single cylinder prototype (4-stroke cycle) engine with gasoline fuel showed that the maximum BMEP was 1.0 MPa and the maximum brake thermal efficiency was 37.7 % (217 g/kW.h).

A new type of internal combustion engine has been developed. The new idea incorporates an impinging part in the central piston cavity. The fuel spray is injected against the impinging area, spreads and forms a fuel mixture. Since a comparatively rich fuel mixture always stays around the impinging part and ignition is acomplished at the center of the rich fuel mixture, steady, instantaneous and high-speed combustion is possible. As the fuel mixture is always formed in the cavity, there is little fuel in the squish area. Therefore, it is possible to prevent end-gas knocking, and in spite of the use of spark ignition, to operate the engine at higher compression ratio than a conventional premixed SI engine. Experiments with methanol fuel showed that BMEP was 1.1MPa and the maximum brake thermal efficiency was 42%. The combustion noise was lower than that of diesel engine. Brief tests with gasoline showed a maximum brake thermal effiency of 36%.