Search Results

The paper considers a novel waste heat recovery (WHR) system integrated with the engine architecture in a hybrid electric vehicle (HEV) platform. The novel WHR system uses water as the working media and recovers both the internal combustion engine coolant and exhaust energy in a single loop. Results of preliminary simulations show a 6% better fuel economy over the cold start UDDS cycle only considering the better fuel usage with the WHR after the quicker warm-up but neglecting the reduced friction losses for the warmer temperatures over the full cycle.

Engine cooling systems are usually designed to meet two rare and extreme conditions; driving at maximum speed and driving up a specified gradient at full throttle while towing a trailer of maximum permitted mass. At all other times, the cooling system operates below its maximum capacity with an incurred drag penalty. In this work it is being suggested to design the system using the existing methods and then vary the area of the cooling air intakes to permit the minimum amount of cooling air for adequate engine cooling. A full-size, Australian made Ford Falcon car (a large modern 'family' saloon) was tested at the Monash University Aero-acoustic Wind Tunnel. The cooling air intakes of the vehicle were shielded progressively until fully blocked. Four different possibilities of shielding were investigated with the aim of determining the variation of drag reduction with the shielding method employed.

Two domains of aerodynamic testing of vehicles are identified; one representing typical driving conditions, where the average atmospheric wind is less than about 10 m/s; the other representing driving under extreme wind conditions for safety considerations. The first domain influences fuel consumption and other parameters related to driving comfort (e.g. aerodynamic noise, transient forces and transient moments experienced during general driving), whereas the second needs to be assessed for stability considerations. The purpose of this paper is to document turbulence commonly encountered by vehicles moving at highway speeds under typical driving conditions. In order to document this, data obtained from hot-wire anemometers fitted above a moving vehicle are presented. It was found that longitudinal and lateral turbulence intensities ranged between 2.5% to 5% and 2.0% to 10% respectively.

Wind tunnels which are large enough for full-scale trucks are rare, and the cost of satisfactorily-detailed models for smaller tunnels is high. The work presented shows the results from the application of a method which provides an over-the-road evaluation of the incremental changes in fuel consumption and drag coefficient produced following the addition of a variety of aerodynamic drag reducing devices to a tractor-trailer truck combination. The devices tested were an aerodynamic sunvisor, a roof-mounted air deflector, cab extenders, cab skirts, a trailer nose fairing, a set of trailer quads (quarter-rounds), and trailer skirts which were mounted on a low-forward-entry tractor and high box-van trailer. The significant differences between the wind tunnel and on-road drag reductions suggest that the effects of on-road wind turbulence can substantially reduce the wind tunnel results even though a 1.5% turbulence intensity level was used in the tunnel experiments.