Search Results

In the present study, several welded beam and plate specimens are fabricated using an electrical resistance type spot welder and studied experimentally applying the frequency response function approach. The experimental data is used to guide the dynamic finite element modeling effort, and to determine the weld joint representation that most accurately characterizes the measured dynamic response. The results reveal the compliant nature of the spot welds at higher frequencies and in applications consisting of more complex geometrical structures and boundary conditions. This finding shows the inadequacy in the classical rigid element representation that is widely used in current dynamic modeling practices.

Vehicle NVH performance is significantly affected by the dynamics of various primary systems. In the automotive industry, different design activities or vendors are responsible for designing various different systems simultaneously. Therefore, it is highly desirable to gain a better understanding of the individual system characteristics and the interaction between the primary systems to achieve a desirable overall NVH performance. Unfortunately, it is usually quite difficult to construct a proper fixture to accurately measure and quantify the actual uncoupled system characteristics. This paper examines an alternate approach of applying the FRF-based substructuring method to back-calculate the system response characteristics from the full vehicle system measurements. The results are then used to forward-compute the dynamic response of the vehicle, which are also validated by comparison to the direct response function measurements.

The changes of dynamic frequency response, commonly used to determine the dynamic characteristic of built-up structures, were studied over the entire fatigue failure process for tensile-shear spot-welded joints. The results of an experimental study showed that the natural frequency varies non-linearly with the fatigue damage fraction. This behavior was modeled using finite element analysis of a progressively growing crack, initiating at the joining surface, then progressing to the outside surface of the specimen, and finally extending from the spot weld nugget. The relationship between dynamic frequency response and crack propagation may be applied to study effect of aging (high mileage) in NVH quality.

The design of automotive components for low structure-borne interior noise and vibration requires the ability to reliably simulate total vehicle system response over a wide operating frequency range. This implies that the car body, its interior acoustic cavity, and critical structural components must be included in this overall dynamic model. Unfortunately, most noise and vibration problems occur in the 200-1000 Hz frequency range where existing finite element and experimental modal methods have limited applicability. This is due to the high modal density, high damping levels, and sensitivity to fine geometric detail. Moreover, it is highly doubtful that these methods will ever be practical tools for the study of the total body dynamics over the frequency range of 200-1000Hz. In this paper, a practical hybrid experimental-analytical approach is proposed in response to the need to simulate high frequencies structure-borne noise and vibration in automotive systems.

A new multi-level substructuring approach is proposed to predict the NVH response of driveline systems for the purpose of analyzing rear axle gear whine concern. The fundamental approach is rooted in the spectral-based compliance coupling theory for combining the dynamics of two adjacent subsystems. This proposed scheme employs test-based frequency response functions of individual subsystems, including gear pairs, propshaft, control arms and axle tube, in free-free state as sequential building blocks to synthesize the complete system NVH response. Using an existing driveline design, the salient features of this substructuring approach is demonstrated. Specifically, the synthesized results for the pinion-propshaft assembly and complete vehicle system are presented. The predictions are seen to be in excellent agreement with the experimental data from direct vehicle measurements.