Search Results

Enhancement of methanol combustion in a direct injected Diesel engine using catalytically coated glow plugs was examined for platinum and palladium catalysts and compared to a non-catalytic baseline case. Experiments were performed for 6 and 10 brake Kilowatts (bKW) at 2500 rpm. Comparisons were made based on combustion, performance, and emissions including carbon monoxide (CO), oxides of nitrogen (NOx), unburned hydrocarbons (UHC), unburned methanol (UBM), and aldehydes. Results show a decrease in glow plug temperature of 100 K is achievable using platinum catalysts, and 150 K for palladium. Furthermore, the palladium catalyst was found to provide better combustion characteristics than the platinum catalyst. Also, the use of both catalysts produced lower aldehyde emissions, and the palladium reduced NOx emissions as well. However, unburned methanol increased for both catalytic glow plugs with respect to the non-catalytic case.

The effects of platinum and palladium catalysts on the enhancement of methanol combustion were investigated in a high pressure flow reactor and in a single-cylinder, D.I. Diesel engine. Initial studies were carried out in the flow reactor to determine the effect of catalyst temperature and equivalence ratio on the products of methanol combustion. Afterwards, Diesel engine studies were performed with in-cylinder catalysts applied to the exhaust valves in order to maintain high catalyst temperature required for high reactivity. Comparisons were based on performance, combustion characteristics, and emissions. Results of the flow reactor studies show that the catalytic ignition temperature, found to be 570 K, did not vary significantly with equivalence ratio. The Diesel engine experiments revealed that a decrease in glow plug temperature of 400 K was achievable while providing better performance and reduced emissions, including aldehydes, compared to the non-catalytic case.

An experiment was performed using an optically accessible direct injection (DI) diesel engine to investigate the effects of exhaust gas recirculation (EGR) on diesel combustion. EGR was simulated using nitrogen and carbon dioxide as intake air diluents. Timing was adjusted to maintain constant start of combustion for all cases. Both diluents were found to be effective in reducing emissions of oxides of nitrogen. Soot emission was not changed by the addition of nitrogen; however, carbon dioxide substantially reduced soot emission while simultaneously reducing NOx emissions. NOx is reduced by intake air dilution is a change in flame temperature.

The potential for catalytically enhanced ignition in low-heat rejection Diesel engines has been experimentally studied under engine simulated conditions in a high pressure chemical flow reactor. Results are presented for propane oxidation on platinum at 6 and 10 atmospheres, at temperatures from 800K to 1050K, and at equivalence ratios from 0.5 to 4.0. For turbulent transport rates which are typical of those in an engine, as much as 20% of the fuel was found to react on the catalyst before the onset of the gas-phase ignition reactions. Depending on the adiabaticity of the combustion chamber walls, this could lead to significant thermal enhancement of the gas-phase ignition process. Evidence of chemical enhancement was also observed, at 10 atm under very fuel rich conditions, in terms of a change in the concentration and distribution of the hydrocarbon intermediate species. Possible mechanisms for the observed chemical enhancement due to surface generated species are discussed.