Search Results

Flame propagation at elevated pressures for propane, butane and autogas (20% propane and 80% butane by mass) were investigated. Flame arrival time was measured using ionization probes installed along the wall of a cylindrical combustion chamber. Flame radius was also measured using a laser schlieren technique. Results showed that the flame front speed decreased with increasing initial pressure, and the initial pressure effect on maximum flame front speed was correlated by the relationship Sf = 175·pi-0.15 (for Φ=1.0). Characteristics of flame front speed between propane, butane and autogas were very similar, whereas at fuel-rich conditions flame front speed of butane and autogas were higher than that of propane. A thermodynamic model to predict flame radius and speed as a function of time was derived and tested using measured pressure-time curves.

Pilot injection and two other forms of auxiliary fuel introduction have been studied for their effects on diesel engine combustion and emissions. A two-stroke diesel has been equipped with an electronic solenoid-controlled unit injector such that the injector can operate with pilot injection. In addition, the engine has been fitted with experimental air-blast atomizing injectors in the inlet port and intake manifold. In-cylinder pressure, Bosch smoke, exhaust hydrocarbons, NO and NOx emissions measurements have been made for a range of engine conditions. In addition, two fuels have been tested to observe the effects of fuel blend on the auxiliary fuel behavior. In general, the effect of auxiliary fuel introduction is to reduce ignition delay and rate-of-pressure rise. This tends to result in a decrease in NO emissions. Unburned hydrocarbons and smoke tend to increase, although not in every case.

Performance and emissions of an LPG lean burn engine for heavy duty vehicles were measured. The piston cavity, swirl ratio, propane - butane fuel ratio, and EGR were varied to investigate their effects on combustion, and thus engine performance. Three piston cavities were tested: a circular flat-bottomed cavity with sloped walls (called the “bathtub” cavity), a round bottomed cavity (called the “dog dish” cavity), and a special high-turbulence cavity (called the “nebula” cavity). Compared to the bathtub and dog dish cavities, the nebula type cavity showed the best performance in terms of cyclic variation and combustion duration. It was capable of maintaining leaner combustion, thus resulting in the lowest NOx emissions. High swirl improved combustion by achieving a high thermal efficiency and low NOx emissions. In general, as the propane composition increased, cyclic variation fell, NOx emissions increased, and thermal efficiency was improved.