Search Results

This paper deals with the correction of aerodynamic interference effects taking place between the nozzle of an open jet wind tunnel and a test model. In order to deduce correct aerodynamic coefficients these interference effects have to be allowed for in the determination of the correct wind tunnel speed. In open jet wind tunnels basically two different methods are used to determine the tunnel speed. One is the so-called nozzle-method, utilizing the pressure difference down the nozzle to determine the nozzle exit velocity or tunnel speed. The other procedure is the so-called plenum-method, where the pressure difference between the settling chamber and the surrounding plenum chamber of the test section is measured and used. In this paper it is shown that both methods yield a systematic error, since the velocity distribution in the nozzle differs from the velocity distribution in an unbounded stream measured at the same distance from the model.

In open jet wind tunnels with high blockage ratios a sharp rise in drag is observed for models approaching the nozzle exit plane. The physical background for this rise in drag will be analyzed in the paper. Starting with a basic analysis of the dependencies of the effect on model and wind tunnel properties, the key parameters of the problem will be identified. It will be shown using a momentum balance and potential flow theory that interaction between model and nozzle exit can result in significant tunnel-induced gradients at the model position. In a second step, a CFD-based investigation is used to show the interaction between nozzle exit and a bluff body. The results cover the whole range between open jet and closed wall test section interaction. The model starts at a large distance from the nozzle, then moves towards the nozzle, enters the nozzle and is finally completely inside the nozzle.

The reference pressures are determined in automotive wind tunnels by measurement of pressures and pressure differences at upstream positions along the wind tunnel nozzle. For closed wall wind tunnels usually the so called nozzle method is used, where the volume flux is calculated from a pressure difference measured at the nozzle contour and a calibration factor determined in the empty test section. For open jet wind tunnels a choice is available between nozzle and plenum method. For the plenum method the reference static pressure is taken from the plenum chamber and the dynamic pressure also refers to the plenum conditions. The static reference pressure in closed wall tunnels is calculated by subtracting the dynamic pressure from the total pressure in the settling chamber. In this paper, the definitions and the differences between the two methods are discussed in detail.