Search Results

In the recent years, the interaction between human driver and Advanced Driver Assistance System (ADAS) has gradually aroused people’s concern. As a result, the concept of personalized ADAS is being put forward. As an important system of ADAS, Lane Keeping Assistance System (LKAS) also attracts great attention. To achieve personalized LKAS, driver lane keeping characteristic (DLKC) indices which could distinguish different driver lane keeping behavior should be researched. However, there are few researches on DLKC indices for personalized LKAS. Although there are many researches on modeling driver steering behavior, these researches are not sufficient to obtain DLKC indices. One reason is that most of researches are for double lane change behavior which is different from driver lane keeping behavior. The other reason is that the researches on driver lane keeping behavior only provide model structure and rarely discuss identification procedure such as how to select suitable data.

Electric power steering systems (EPS) greatly improve fuel performance over conventional hydraulic power steering systems, and therefore being increasingly adopted. However, it is very important to evaluate the mechanical noise and to identify the correct noise source in steering systems, because an EPS has vibration sources such as at the motor gear reducer, manual gears and intermediate joints. In order to identify the noise source, a technique based on time-frequency analysis using the wavelet transform (WT) has been focused on which uses a mother wavelet (MW) that is derived mathematically. The measured signal is adopted as the MW. In this study, applying this method to time-varying signals, a new concept of the Wavelet Instantaneous Correlation Value (WICV) is discussed and is used to identify the noise source.

Sliding intermediate shaft of Electric Power Steering (EPS) system is used for torque transmission from steering wheel or motor and buffering reverse input from tire. Polyamide coating material with good sliding properties is treated in the sliding types of intermediate shaft. Conventionally, sliding types of intermediate shaft with polyamide coating have been used in vehicle interior. On the other hand, extension of applied area to engine room is needed. However, in high temperature conditions, there is concerns about increase of friction coefficient and wear volume of polyamide by deterioration of sliding properties of polyamide. Therefore, improvement of sliding properties of polyamide in high temperature is necessary. In this research, we examined sliding properties of polyamide blended with metal stearate in high-temperature to use polyamide in high temperature compared to conventional environment. As resin material, we used polyamide 610 blended with metal stearates.