Search Results

An innovative hydrogen DI system was conceived, realized and tested that requires only 12 bar rail pressure, typical value of PFI systems, and does not need special injectors. The purpose is to combine the well-known benefits of DI with the ones of PFI. The injection is accomplished in two steps: at first hydrogen, metered by an electroinjector (a conventional one for CNG application), enters a small intermediate chamber; then it is injected into the cylinder by means of a mechanically actuated valve that allows very high flow rate (compared with the one of electroinjectors). In-cylinder injection starts at intake valve closing (an earlier injection start could lead to backfire) and stops early enough to allow proper charge homogeneity and, in any case, before cylinder pressure rise constrains hydrogen admission. The prototype engine was realized modifying a production single-cylinder 650 cm₃ engine with three intake valves.

A low-pressure hydrogen direct-injection solution is presented that allows some typical benefits of direct injection, such as high specific power and backfire prevention, plus low residual storage pressure, that improves vehicle range and is a typical advantage of external mixture formation. Since the injection must end early enough to allow good charge homogeneity and, in any case, before in-cylinder pressure rise constraints hydrogen admission, especially at heavy loads hydrogen flow to the cylinder is higher than present electro-injectors allow. The injection is realised in two steps: hydrogen flow rate is simply controlled by a conventional CNG electro-injector that feeds a small intermediate chamber. From this chamber hydrogen next enters the cylinder in a short crank angle period by means of a mechanically-actuated valve that opens at the intake valve closure to avoid backfire.

The paper describes the CFD analysis, the arrangement and the first experimental results of a single-cylinder engine that employs an innovative low-pressure hydrogen direct-injection system, characterized by low fuel rail pressure (12 bar) and consequent low residual storage pressure. The injection is split in two steps: at first hydrogen is metered and admitted into a small intermediate chamber by an electroinjector (a conventional one usually employed for CNG), next a mechanically actuated poppet valve, that allows high volumetric flow rates, times hydrogen injection from the intermediate chamber to the cylinder within a short time, despite the high hydrogen volume due to the low injection pressure. Injection must be properly timed to maintain pressure below 6 bar (or little more) in the intermediate chamber and thus keep sonic flow through the electroinjector, to maximize volumetric efficiency and to avoid backfire in the intake pipe.