Search Results

Numerical characterization of surfaces with deep dimples, e.g. Laser Textured Surfaces, poses questions relative to the standard filtering techniques used to separate roughness, waviness and form effects. Usual roughness filters would produce a reference plane several micrometers “below” the surface. If this surface plane will be used as reference for mixed lubrication modeling, no hydro dynamic pressures and excessive high contact pressures may be calculated. The conventional roughness filters, Gaussian and Rk, and 4 other filters were applied in an artificially dimpled surface in order to demonstrate and especially to discuss how the Greenwood contact parameters were affected. Depending on the filter used, the estimation of the minimum surface separation for asperity contact varied two magnitude orders.

Piston ring radial pressure effects both the manufacturability of the ring as well as its performance in the engine. While lack of radial contact can cause increased blow-by and lubricant oil consumption, high local contact pressure can cause excessive wear and even scuffing. Current methods to evaluate ring radial pressure fail to identify subtle, local pressure changes. To overcome such limitation, a new method to evaluate ring radial pressure at each peripheral angle was developed. In this experimental procedure, the ring free shape is recorded by an optical device and then this free shape is used as input to code that calculates its radial pressure distribution. In order to validate this method, six different sample variants of ring pressure distribution, (i.e. free shape), have their radial pressure evaluated by two different methods: 1,) the new procedure and 2,) a mechanical jig with 11 circumferentially spaced radial load sensors.

The Greenwood model has been extensively used for calculation of the asperity pressures under mixed lubrication conditions, but usually assuming that the surfaces are gaussian. In this work, the Greenwood parameters are calculated from actual, non-gaussian, engine surfaces measured by White Light Interferometer. Results from 2D profiles and 3D measurements are compared. An improved way to calculate the Greenwood parameters and to apply them for estimation of the contact area and pressure is described. To illustrate the methodology, some examples of topography characterization and modeling for engine liners are presented. The influence of the asperity summit height average on the predicted contact area calculation is discussed. To explore and validate the proposed method, several WLI measurements from different engine HDD liners were analyzed using a proprietary code.

With the current use of bio-renewable fuel, the application of Ethanol in Flex-Fuel vehicles presents a very low CO2 emission alternative when the complete cycle, from plantation, fuel production, till vehicle use, is considered. In Brazil more than 80% of the car production is composed of Flex-Fuel vehicles. Due to the lower heating content of the Ethanol, more aggressive combustion calibrations are used to obtain the same engine power than when burning gasoline. Such Ethanol demands, associated with the continuous increase of engine specific power has lead to thermo-mechanical loads which challenges the tribology of piston rings. The ethanol use brings also some specific tribological differences not very well understood like fuel dilution in the lube oil, especially on cold start, corrosive environment etc. Under specific driving conditions, incipient failures like spalling on nitrided steel top rings have been observed.

In the present work, a system approach to the tribological optimization of passenger car engines is demonstrated. Experimental data and simulation results are presented to demonstrate the role of surface specifications, ring pack, and lubricant on the piston/bore tribology. The importance of in-design “pairing” of low-viscosity motor oils with the ring pack and the cylinder bore characteristics in order to achieve maximum reduction in GHG emissions and improvement in fuel economy without sacrificing the endurance is elucidated. Earlier motored friction data for two different gasoline engines - Ford Duratec and Mercedes Benz M133 - using motor oils of different viscosity grades are now rationalized using AVL EXCITE® piston/bore tribology simulations. The main difference between the engines was the cylinder bore surface: honed cast iron vs thermally sprayed, and the valve train type: direct-acting mechanical bucket (DAMB) vs roller finger follower (RFF).