Search Results

1 The wall-flow Diesel Particulate Filter (DPF) is currently the most common after-treatment system used to meet the particulate emissions regulations for automotive engines. Today’s technology shows the best balance between filtration efficiency and back-pressure in the engine exhaust pipe. During the accumulation phase the pressure drop across the filter increases, thus requiring periodic regeneration of the DPF through after and post fuel injection strategies. This paper deals with the development of a control oriented model of a catalytic silicon carbide (SiC) wall flow DPFs with CuFe2O4 loading for automotive Diesel engines. The model is intended to be used for the real-time management of the regeneration process, depending on back-pressure and thermal state.

Nowadays the high competition reached by the automotive market forces Original Equipment Manufacturers (OEMs) towards innovative solutions. Strict emission standards and fuel economy targets make the work hard to be accomplished. Therefore modern engines feature complex architecture and embed new devices for Exhaust Gas Recirculation (EGR), turbocharging (e.g. multi-stage compressors), gas after-treatment (e.g. the Selective Catalyst Reduction (SCR)) and fuel injection (either high or low pressure). In this context the Engine Management System (EMS) plays a fundamental role to optimize engine operation. The paper deals with fuel spray and combustion simulation by a multi-zone phenomenological model aimed at the steady-state optimal tuning of the injection pattern.

Diesel engines are attractive thanks to good performance in terms of fuel consumption, drivability, power output and efficiency. Nevertheless in the last years, increasing restrictions have been imposed to particulate emissions, concerning both mass (PM) and number (PN). Different technologies have been proposed to meet emissions standards and the wall-flow Diesel Particulate Filter (DPF) is currently the most common after-treatment system used to trap PM from the exhaust gases. This technology exhibits good features such that it can be regenerated to remove any accumulation of PM. However, this process involves oxidation of the filtered PM at a high temperature through after and post fuel injection strategies, which results in an increase of fuel consumption and may lead to physical damages of the filter in the long term. This work deals with the experimental testing of a catalytic silicon carbide (SiC) wall flow DPF, aiming at decreasing the soot oxidation temperature.