Search Results

In 2021 the Federal Aviation Administration in collaboration with the National Research Council of Canada performed research on altitude ice crystal icing of aircraft engines using the modular compressor rig, ICE-MACR, in an altitude wind tunnel. The aim of the research campaign was to address research needs related to ice crystal icing of aircraft engines outlined in FAA publication Engine Ice Crystal Icing Technology Plan with Research Needs. This paper reports the findings on ice accretion from a configuration of ICE-MACR with two compression stages. Inherent in two-stage operation is not just additional fracturing and heating by the second stage but also higher axial velocity and potentially greater centrifuging of particles. These factors influence the accretion behavior in the test article compared to single stage accretion.

High Ice Water Content (HIWC) has been identified as a primary causal factor in numerous engine events over the past two decades. Previous attempts to develop a remote detection process utilizing modern commercial radars have failed to produce reliable results. This paper discusses the reasons for previous failures and describes a new technique that has shown very encouraging accuracy and range performance without the need for any modifications to industry’s current radar design(s). The performance of this new process was evaluated during the joint NASA/FAA HIWC RADAR II Flight Campaign in August of 2018. Results from that evaluation are discussed, along with the potential for commercial application, and development of minimum operational performance standards for future radar products.

NASA's Deep Space Network (DSN) uses high-power transmitters on its large antennas to communicate with spacecraft of NASA and its partner agencies. The prime reflectors of the DSN antennas are parabolic, at 34m and 70m in diameter. The DSN transmitters radiate Continuous Wave (CW) signals at 20 kW - 500 kW at X-band and S-band frequencies. The combination of antenna reflector size and high frequency results in a very narrow beam with extensive oscillating near-field pattern. Another unique feature of the DSN antennas is that they (and the radiated beam) move mostly at very slow sidereal rate, essentially identical in magnitude and at the opposite direction of Earth rotation.

This paper describes the recently established Commercial Aviation Alternative Fuel Initiative (CAAFI), including its goals and objectives, as well as presents an alternate fuel roadmap that was originally generated by industry and refined by the CAAFI stakeholders. CAAFI is designed to coordinate the development and commercialization of “drop-in” alternate fuels (i.e. fuels that can directly supplement or replace crude oil derived jet fuels), as well as exploring the long-term potential of other fuel options. The ultimate goal is to ensure an affordable and stable supply of environmentally progressive aviation fuels that will enable continued growth of commercial aviation. This initiative is organized into four sub-groups: Research and Development (R&D), certification, environment, and economics & business. The R&D group seeks to identify promising new drop-in alternate fuels, and to foster coordination of development efforts.

The FAA Office of Aviation Medicine has developed, delivered, and tested a variety of training systems over the past decade. The systems, their design, and guidance materials are directly transferable to the aviation industry at no cost. This paper describes the many training systems that are available.

Weather is a major cause of aircraft accidents and incidents and the single largest contributor to air traffic system delays. Through improvements in the knowledge of current weather conditions and reliable forecasts, the Federal Aviation Administration (FAA) can improve aviation safety, increase system capacity, and enhance flight planning and fuel efficiency. The FAA has established an Aviation Weather Research (AWR) program to address specific requirements for weather support to aviation by providing the capability to generate more accurate and accessible weather observations, warnings, and forecasts and also by increasing the scientific understanding of atmospheric processes that spawn aviation weather hazards. The goal of AWR is to provide meteorological research that leads to the satisfaction of specific aviation weather requirements.

Numerical simulations indicate that blast loading on aircraft structural joints can impart loading rates in excess of 10 Mlb/sec (ten million pounds per second, Reference 1). Experimental evidence, on the other hand, suggests that mechanical joint failure loads are highly loading rate dependent; for example, the failure load for a dynamically loaded tension joint can double from its static value. This paper discusses the progress and to-date findings of research on the assessment of strength failure of aircraft structural joints subjected to loading rates expected from an internal explosive detonation, and several associated experimental procedures to generate such dynamic loading. This work is conducted at MDC and at the University of Dayton Research Institute (UDRI) in support of the FAA Aircraft Hardening Program.

Voice communications are crucial to safe and efficient air traffic operations. Controllers are required to use standard phraseology, and pilots are encouraged to use it when talking to controllers. Incomplete or inaccurate communications were implicated in mishaps such as the Tenerife accident. This research examined the frequency of phraseology deviations in a sample of 5,000 transmissions from 3 terminal facilities. The Aviation Topics-Speech Acts Taxonomy (ATSAT) was used to develop baseline data and analyze controller/pilot communications. Clearance instructions were transmitted most frequently and they contained a higher percentage of deviations from standard phraseology than any other speech act category. Identification of the types of errors typically associated with specific miscommunications could result in implementing new training approaches that ensure a higher compliance with standard procedures and improve standard phraseology usage.

As a part of its International Aging Aircraft Research Program, the Federal Aviation Administration is establishing a state-of-the-art Flight Loads Data Collection Program. Data collected in this program will provide the necessary mission profiles and load spectra information to characterize typical fleet service usage for the regional/commuter service life extension program. In addition, these data are applicable for both a safe life fatigue analysis and a damage tolerance fracture mechanics analysis. This paper describes the FAA approach and schedule for instrumenting fleet service aircraft, and the data reduction process.

Since the first airplane was certified in 1927, the standard configuration has been with the main lifting surface or surfaces forward of the stabilizing surface. Although some of the advantages of the canard configuration were recognized quite early - by the Wright Brothers, for example - canard surfaces have been used to date only as additional control surfaces on some military airplanes, and on some amateur built airplanes. As a result, the Airworthiness Regulations of Reference 1 address only tail aft configurations. When FAA was first approached regarding certification of a canard configured small airplane, an FAA/Industry Empennage Loads Working Group was formed to develop technical proposals for the necessary rule changes and policy. The concerns addressed by this working group are discussed in the following sections.

Microprocessor technology is allowing functions in aircraft to be implemented to a greater degree by digital process control than by conventional mechanical or electromechanical means. A review of this technology indicates a need for updated certification criteria. A high level of commitment to the technology such as fly-by-wire is completely beyond the scope of existing certification criteria. This paper emphasizes the areas of software validation levels, increased concern with basic power system qualification, and increased environmental concerns for electromagnetic interference and lightning.

Powered-lift aircraft, such as the V-22 tilt-rotor, are likely to spin-off a civil version. The present FAA airworthiness certification standards are not considered to be adequate for these unique aircraft. The FAA has drafted certification criteria and held a public conference to review the draft and identify significant technical certification issues that require further effort to establish correct standards for powered-lift aircraft. Some of those issues are discussed.

This paper presents a description of several Federal Aviation Administration (FAA) incident data systems that contain information on events which result primarily from human error. These data systems include reports of near midair collisions, operational errors, pilot deviations, and events reported through the Aviation Safety Reporting System (ASRS). Over 17,000 incident reports are received and stored in these data bases annually. This paper discusses the information content of the data bases, reporting procedures, system limitations, proposed improvements, and uses of the data.

The Federal Aviation Administration has placed increasing emphasis on modern information systems to achieve safety improvements. The ASAS (Aviation Safety Analysis System) is a comprehensive new system to upgrade significantly the agency's ability to collect process and disseminate safety-related information.

In view of the fact that future generations of derivative or new aircraft will be faced with problems of increasing operating efficiency, new and more advanced technology will have to be introduced. To this end, the Federal Aviation Administration has been examining the certification question and has concluded that simulation may be increasingly important in the future certification activities. Through a contract with Lockheed Aircraft Company, the FAA will be able to review past use of industrial simulation in connection with certification.

In the early design stages of the advanced technology high-bypass-ratio engines, it became evident that maintainability considerations and more effective maintenance concepts would be necessary to achieve higher reliability and more economically successful powerplants. This paper reviews the major design considerations from a maintainability standpoint. It describes the concepts developed specifically to provide more effective maintenance for the wide-body jets. It discusses the effectiveness of these programs, and provides an insight into new philosophies and trends envisioned by the Federal Aviation Administration for future maintenance management programs.

The present regulatory tool for assessment of aircraft smoke emission, the Ringelmann Chart, is described; some of the shortcomings associated with its use for aircraft are discussed; research and development efforts to improve on this system are described. The gaseous pollutants, their relative importance in an airport area and research underway or needed is also discussed.